Battlezone Caberat ST-166 1st Printing Backdoor Sheet
Battlezone (rev 2) (Atari, 1980) · Backdoor Sheet · 1 pages · original scan
| ae | ET | | | . |
CABARET SELF-TEST PROCEDURE
Results it
Instruction Test Passes Results if Test Fails
| 1, | Set self-test | ‘Alter about 3 | RAM FAILURE Is indicated by @ sequence of 1 to 10 tones. You will hear a short low |
| switch to on post | seconds, the TV | tone for each good RAM chip, and a long high tone for a failing RAM chip, The test | |
| tion (see Figure 5), | monitor displays the | stops with the first failing RAM-chip pair (example. J2 and H2 are a pain. To restart the |
picture below. sequence, press the reset pushbutton on the Battlezone™ Analog Vector-Generator PCB, or set the self-test switch to off, then again to the on position. Identify the bad RAM chip with the table below. Example: four short iow tones followed by a long high tone indicates failure of RAM at location B2 CENTER COIN MECH
MULTPLIER LEFT Long High Tone Bad RAM Chip Location
1st J2 MECH OF A 2MECH DOOR) Po} Fe
RIGHT COIN MECH ora a2
MULTIPLIER ath At
sth 82 6th 81 7th c2 8th cr oth 02 10th oO
ROMI/PROM FAILURE is indicated by two columns of numbers on the left side of the screen, The number in the left column indicates the location of the tailing ROM/PROM(s). Identify the bad ROM/PROM with the table immediately below Ignore the hexadecimal numbers in the right column.
Displayed No. Failing ROM Failing PROM
| 0 | BIc3* | BIC3*, E3 |
| 1 | A3 | A3, FIHS |
2 ey
| ‘SWITCH | ‘SWITCH | 3 | FH |
| AT PIO | aT M10 | 4a | Jt |
| (TOP ONE) | (BOTTOM ONE) | 5 | KI |
6 uM?
| DISPLAY OF COMPLETE | 7 | niet |
CHARACTER SET “It ROM or PROM BV/C3 is bad, you will hear a continuous low tone, and the program may be unable to display a screen image. **if ROM N1 is bad, program will be unable to produce tones in RAM test
MATH BOX FAILURE |s indicated by a single letter displayed in the upper nght corner of the display. Math-box failure is explained in the Signature Analysis Procedure, on the game schematic Sheet 1, Side B. Identity the failure with the table below
Displayed Letter Failure T Time out error 4 Data error—nigh byte L Data error—low byte
- Activate slam switch, ail control panel switches and coin door switches. When satistied with test, set self-test switch to off posttion As switch activates, you'll hear a low beep As switch deactivates, you'll hear a high You will not hear a low or high beep far the defective switch
- Sounds Test (Optional) You may test the hardware generated sounds by starting a game and proceeding as follows: Engine Rumble (idle): Should be heard as soon as start button 1s pushed. Engine Rumble (Active: Pushing both contro! handles forward ‘should cause an increase in pitch, Releasing contro! handles should cause engine rumble to return to idle. Loud Shot: Press the fire button
Loud Explosion: Heard when you get hit, indicated by cracked windshield. Soft Explosion: is heard when you hit an enemy tank or another ‘object
Game Option Settings To change toggle positions on the switch assemblies, you need not remove the game PCB. The switches, usually colored biue, are easily accessible when the Battiezone Analog Vector-Generator PCB is mounted in place. When changing the options, verity proper results on the TV monitor display by performing the self-test. Note that changing an ‘option on any of the following eight toggles will cause an immediate change on the TV monitor screen during the self-test. Toggle Settings of 8 Toggle Switch on Battlezone PCB (at M10) (BOTTOM switch when PCB is in game)
| 8 | 7 | 6 | 5 |
‘TM 166 ‘4st printing
Game Price Settings ‘The white block below contains the manutacturer's suggested ‘switch at location P10, on the Battlezone™ Analog Vector-Gene- ‘settings. All numbers 1 thru 8 are toggle settings on the B-toggie rator PCB (the top switch assembly). rs Bonus 50¢ PER PLAY: Sane ee Bonus 5.75 = 2 plays No bonus $1.00 = 3 plays $1.00 = 3 plays
| e?res | 7 | 6 | 8 | sy | 8 | 8 | ||||||
| ‘Straight | On | On | On | On | On | Off | Off | On | On | On | Off | On |
| 3 | 2 | 1 |
On Off
25¢ PER PLAY: Bonus: Bonus: No bonus $.50 = 3 plays $1.00 = 5 plays
| so, | = | s | @o7 | 6 | 8 | 7 | 6 | 6 | |||
| Straight | On | On | On | On | On | On | Off | On | Of | On | On |
25¢ Door
| ©, | ss | 2 | 4 | @ 43 | 2 | 4 | 3 | 2 | 4 | |||
| On | On | Off | On | On | On | Off | On | On | Off | On | ||
| a | a | 87 | 6 | 5 | 8 | 7 | 6 | 58 | ||||
| 25¢/$1.00 | On | On | On | On | On | On | Off | On | On | Off | On | On |
Door or
| 256/256/81.00 OF | as | £ | 4 | oO, | a | O, | 3 | 2 | 4 | ||
| Door | On | Off | Off | On | On | Of | Off | On | Off | Off | On |
| Circled | numbers | refer to | coin-door | labels | you |
should use with each situation. Note: Battiezone cannot be set for a 2-coin minimum.
For your information, we have defined below the switch set- Need to temporarily set the Battlezone™ game on free play. or if tings tor those options relating to game price, coin mechanism you have German coin mechanisms in your door. ‘multiphers, and bonus play. This information 1s useful in case you
Toggle Settings of 8-Toggle Switch on Battlezone PCB (at P10). TOP switch when PCE is in game
| 7 | 6 | 5 | 4 | 3 | 2 | 1 |
Option Free play 1 coin* for 2 plays 1 coin® for 1 play 2coms* fort play $
On Right coin mech x Right coin mech x x x On Right coin mech on Right com mech
| On | Center coin mech x 1 | $ | (Both these settings affect |
| ott | Center coin mech x 2 | the left mech in a 2mech |
door) goog g
On No bonus coins For every 2 coins” inserted, game logic adds 1 more coin* On For every 4 coins” inserted, game logic adds 1 more coin* For every 4 coins” inserted, game logic adds 2 more coins* $ For every 5 coins” inserted, game logic adds 1 more coin* Sf 8e £ 3°: g
*In the U.S., @ “coin” is detined as 25¢ In Germany a “coin” is BATTLEZONE ANALOG 10M. VECTOR-GENERA’ $ Manufacturer's suggested settings To achieve bonus plays, all coins must be inserted before pushing
© @@ 2 coins 1 play AL @ $1 coin = plays o @@ 2 coins =1 play
| o. | @ | 1 coin = | 1 play |
2 play minimum ry 5
| @ | 1 coin = | 1 play |
J a
On On Off Off On On On orf ott On ort or
ES ggg ott oft g
gees Es} Game starts with 2 tanks Game starts with 3 tanks $ Game starts with 4 tanks Game starts with 5 tanks Missile appears after 5,000 points Missile appears after 10.000 points $ Missile appears atter 20,000 points Missile appears after 30,000 points No bonus tank Bonus tank at 15,000 and 100,000 points $ Bonus tank at 25,000 and 100,000 points Bonus tank at 50,000 and 100,000 points English language $ French language German language ‘Spanish language Coin Counter Option Settings
[These toggles determine which coin mechanisms activate which counters]
Toggle Settings of 4Toggle ‘Switch on Game PCB (at L11)
| 4 | 3 | 2 | 1 | For Games Having These Coin Doors: | Option |
On | On | Thai 1 Baht Baht, German 1 DM/1 DM, U.S. 25¢i- All 3 coin mechanisms are 256, Belgian or French 5 Fr/S Fr, Swiss or French same denomination; all 1 Frit Fr, US 25¢/256/25¢, Japanese Y100/Y 100. register on one coin ‘Swedish 1 Kr/1 Kr, U.K, 10 P/10 P, Australian 20). counter. 208, or Italian 100 L100 L
| oft | On | German 2 OM/1 DM, German 1 DM/5 DM, U.S. 25¢/- | Lett and center mechanisms |
250/81, or US 256/81 are same denomination; ght mech is another
| 3 | 3 | denomination Requires two |
< : coin counters.
| g | = | On | oft | ‘No coin door is currently designed for this config- | Left mech 1s one denomina- |
uration tion; center and right mech ‘are another denomination. Requires two com counters. ® ott | of | German 1 M2 DMS DM. Lett, center and nght mechs are 3 different denominations. Requires three coin counters.