CATHODE RAY TOMES

Operation Thunderbolt

Operation Thunderbolt (World, rev 1) (Taito Corporation Japan, 1988) · Manual · 27 pages · 16 sections · original scan

Page 1

TAITO

OUASIRATIICON TUNIS IBCILT..

OPERATING MANUAL

TAITO AMERICA CORPORATION id e

r¢ 660 S. Wheeling Roa

A Wheeling, IL 60090

Telephone (312) 520-9280 Fax (312) 520-1309

Part No. 148-988087

Page 2

SPECIFICATIONS

POWER SUPPLY 128 VAC (68 Hz)

POWER CONSUMPTION 116 WATTS

TV MONITOR 26 INCH COLOR

DIMENSIONS 28.5"W x 40"D x 72"H

TABLE OF CONTENTS

Page Numbers

INSTALLATION .oceeccccccccccccccceceeccersecsserescesecesecees 1

CABINET LAYOUT ce ccecec cece cece cee en sce rsceecccceceecetseeseee 2-5

GAME OPERATION & PLAY INSTRUCTIONS ..ceecsececcceccceceeceeeee GB - 7

SELF-TEST MODE ..ccecccccececcerecccccesescsesescecesssseeeess 8 - 1H

GUN SIGHT SETTINGS .occe eee e ese c cece ccc ee cece cee cereccecessees 9

DIP-SWITCH SETTINGS ..ceececc cece cc ccceccecreeecscceeseesseeee LL - 12

SUB-ASSEMBLY ILLUSTRATIONS & PARTS IDENTIFICATION .......+++.. 13 - 22

  • WARNING *

THIS GAME MUST BE PROPERLY GROUNDED. FAILURE TO DO SO MAY RESULT IN DESTRUCTION TO THE ELECTRONIC COMPONENTS.

Page 3

._GAME_ INSPECTION

Operation Thunderbolt has been thoroughly tested and readied for operation at the factory and should not require any special set-up procedure. However it is suggested that upon receiving your game you examine the following to further insure the game is in proper working condition:

CHECK:

Plug-in connectors are firmly seated. All player control connections are complete. No loose components on p.c. board. Fuses are installed firmly in holders. Coin mechanisms are operating properly. No loose foriegn objects in cabinet (screws, components, etc.) which may cause shorting and result in damage to the game.

If problems do occur or technical assistance is required, please call our customer service department at 312/526-9288.

iL. POWER REQUIREMENTS

The game is shipped ready for operation at 120VAC, 6@Hz with a power consumption of approximately 258 watts.

CAUTION

FOR SAFE OPERATION IT IS STRONGLY RECOMMENDED THE CABINET BE PROPERLY GROUNDED. THIS GAME IS EQUIPPED WITH A THREE CONDUCTOR POWER CABLE. THE THIRD PRONG (round in shape) WILL AUTOMATICALLY GROUND THE GAME WHEN PLUGGED INTO A PROPERLY GROUNDED THREE PRONG RECEPTICAL. IF IT BECOMES NECESSARY TO USE AN ADAPTOR, THE GROUNDING LUG OR WIRE ON THE ADAPTOR MUST BE PROPERLY GROUNDED TO ASSURE SAFE OPERATION.

I1L. GAME INSTALLATION

The following precautions should be followed when installing the game:

  • Handle the game with care so as not to damage the fragile picture tube.

Do NOT install the game in direct sunlight or near a heat source. Doing so might cause the internal temperature of the game to exceed it's maximum operating temperature and could result in damage to the game's components.

  • Do not install the game in excessively dusty or damp environments.
Page 4

This page carries no recoverable text. It is a drawing or a photograph. See the original scan.

Page 5

CABINET (FRONT)

START it (BLUE) |

WOODEN GUN DECK

Page 6

This page carries no recoverable text. It is a drawing or a photograph. See the original scan.

Page 7

CABINET (REAR)

wares arts -— letatatadataneiniehened Gaisiuletetaiaiatsiaiaiaisieiataeaeamemamamameammmnaeemeel | 148-986083 | ON/OFF SWITCH |

146-982068 | ELECTRONIC DRAWER ASSEMBLY

149-991885 | NOT SHOWN | CASTERS !

Page 8

IV. GAME DESCRIPTION

QPERATION THUNDERBOLT

TRANS GLOBAL FLIGHT #528 HAS BEEN HIJACKED BY A HEAVILY ARMED AND DANGEROUS GROUP OF REBELS. IT WAS LAST REPORTED THAT A GROUP OF PASSENGERS WERE REMOVED FROM THE PLANE AND TAKEN INTO CUSTODY AT ENEMY HEADQUARTERS. THEY WILL KILL THE HOSTAGES ONE BY ONE IN 24 HOURS UNLESS THEIR DEMANDS ARE MET. IT IS NOW UP TO YOU TO PENETRATE ENEMY TERRITORY, LOCATE THE HOSTAGES AND RETURN THEM TO SAFETY USING THE DOWNED TRANS GLOBAL AIRCRAFT.

MISSION OBJECTIVES:

  • THE GAME BEGINS...YOUR MISSION IS TO RESCUE HOSTAGES BEING HELD CAPTIVE BY A RADICAL AND HEAVILY ARMED GROUP OF REBELS.
  • CONDUCT RAID ON ENEMY TERRITORY AND COLLECT ADDITIONAL AMMUNITION. SHOOT AIR-DROPPED CRATES TO COLLECT RESERVE SUPPLIES.
  • IF YOUR RAID IS SUCCESSFUL, YOU WILL MAKE CONTACT WITH AN INTELLEGENCE AGENT AND OBTAIN IMPORTANT INFORMATION.
  • BY JEEP, MAKE YOUR WAY TO THE ENEMY HIDE-OUT. THERE YOU WILL FIND HOSTAGES BEHIND LOCKED DOORS. SHOOT THE LOCKS OFF THE DOORS TO FREE HOSTAGES. DO NOT SHOOT THE HOSTAGES!
  • HEAD FOR ENEMY HEADQUARTERS. THERE, BEHIND LOCKED DOORS, YOU WILL FIND MORE HOSTAGES.
  • AFTER RESCUING THE HOSTAGES FROM ENEMY HEADQUARTERS, SECURE YOUR ESCAPE ROUTE TO THE AIRPORT.
  • ONCE YOU'VE ARRIVED AT THE AIRPORT, YOU WILL BOARD A PASSENGER PLANE. INSIDE THE PLANE YOU WILL FIND A SMALL GROUP OF HOSTAGES, MOSTLY WOMEN AND CHILDREN. APPROACH WITH CAUTION....THE PLANE AND PASSENGERS ARE HEAVILY GUARDED.
  • WHEN YOU HAVE SUCCESSFULLY SECURED THE PLANE, HEAD TOWARD THE COCKPIT, WHERE THE PILOT IS BEING HELD AT GUNPOINT. APPROACH CAUTIOUSLY! SHOOTING AND KILLING THE PILOT WILL DESTROY ANY POSSIBILITY OF ESCAPE AND YOUR MISSION WILL FAIL.
Page 9

ITEMS TO BE PICKED UP The player may pick up items by shooting at them. In a two player game, each player is given the same chance to obtain the items. The Player who shoots them is awarded them.

LASER SIGHT.........A laser sight is mounted on the machine gun and the sight position is shown with a red circle on the screen.

BODY ARMOR..........The player can put on a bulletproof vest with which his damage is reduced by half.

MAGAZINE............The number of machine gun magazines is increased by 1.

ROCKET BOMB.........The number of rocket bombs is increased by l.

AMMUNITION..........The number of magazines increases CASE by 3 and the number of rocket bombs increases by 2.

POWER DRINK.........The number of LIFE's is increased by a given number.

FIRST AID...........All of LIFE's recover. KIT p

ITEM BOX..........+..This box contains any of the above items.

Page 10

V._SELF-TEST MODE

A. To enter the Self-Test Mode

  • Turn power OFF.
  • Locate Dip Switch Bank A on the logic pcb and slide switch #3 to the ON position.
  • Turn power ON.

The phrase "INTO TEST MODE" will appear on the screen.

  • ROM/RAM & COLOR MONITOR TEST
  • GUN ADJUSTMENTS - Press the HARDY (right side) button 1 times.
  • GUN SIGHT SETTINGS - Press the HARDY (right side) button 2 times.
  • TEST SWITCH MODE - Press the HARDY (right side) button 1 time, then press the ROY (left side) button once.

B. ROM/RAM & COLOR MONITOR TEST

  • During the first stage of this test the game conducts a self-test of its rom and ram memory and indicates if there is a problem.
  • During the second stage of this test, the screen displays a color bar and crosshatch pattern to assist in adjusting the color monitor.

C. GUN ADJUSTMENTS

  • The data displayed during this test is intended for use by qualified technicians ONLY.
Page 11

D. GUN SIGHT SETTINGS

  • IMPORTANT - If you are NOT setting the gun sights, press the ROY (left side) button to bypass this test.
  • First, you adjust the gun sight for ROY (left side), then you adjust the gun sight for HARDY (right side).
  • To set the sight, adjust the gun sight to a * mark displayed on the screen, then pull the trigger. Always use the sight on the gun. DO NOT use the red circles. (See illustration below.)
  • When setting the sight for either side, ROY or HARDY, always follow this order - UPPER LEFT - CENTER IN - LOWER RIGHT.
  • After finishing the sight adjustments and once the gun sight data is newly recorded, the display will read "EE ROM READ OK". This simply means all the gun sight settings have been completed. Press the HARDY (right side) button twice to exit the sight adjustment mode and enter the SWITCH TEST mode.

(TV Screen)

ALWAYS USE PHYSICAL GUN SIGHTS WHEN MAKING ADJUSTMENTS. DO NOT USE THE RED CIRCLES.

(CENTER IN) 4%

(LOWER RIGHT)

DO NOT USE THIS RED CIRCLE.

USE ONLY Os MARKS.

Page 12

E. TEST SWITCH MODE

  • Press each game control switch to test. When pressed, the display will change from OFF to ON. This indicates the switch is operating properly. (See ilustration below.)
  • When finished testing all game switches, locate Dip Switch Bank A and return switch #3 to the OFF position. Switch the power to the game off and on to return to normal game (ready to play) mode.

( ) TEST SW MODE

COIN A=OFF COIN B=OFF

SERVICE:OFF SELECT 1P=OFF SELECT 2P=OFF

TRIGER 1P=OFF TRIGER 2P=OFF

BOMB 1P=OFF BOMB 2P=OFF

SOUND CODE=*x SOUND OK

8 7 65 43 2 1

DIP SW A HH HH HL H H_ L ON DIP SW B HHH H HH H H_ H OFF

RAM OK

ROM OK J

Qe

INCREASE

INCREASE

Page 13

DIP SWITCH SETTINGS

The following option switch settings were designed to allow the customizing of OPERATION THUNDERBOLT's various game features to suit different environments. When used wisely, the flexibility they offer can maximize game performance and increase potential earnings.

MUST REMAIN IN "OFF" POSITION

CONTINUE PLAY

  • ENABLED DISABLED

SELF-TEST MODE *GAME MODE TEST MODE

ATTRACT SOUNDS *ENABLED DISABLED

PLAY PRICING COIN A co co co co

PLAY PRICING COIN B co co co co onuo

Page 14

w bn ‘a N FUNCTION SETTING

*MEDIUM OFF OFF

DIFFICULTYEASYONOFF
LEVELHARDOFF ON

HARDEST ON ON

INITIAL NO. |*5 / 3 OFF | OFF

OF6 / 4ONOFF
MAGAZINES/7 / 5OFF | ON

ROCKETS 8 / 6 ON ON

NUMBER OF*40OFF | OFF
BULLETS50ONOFF
INA35OFF | ON
MAGAZINE38ONON

DISCOUNTED DISABLED OFF CONTIN. PLAY | *ENABLED ON

MUST REMAIN NONE IN "ON" ON POSITION

&

WHEN THE "DISCOUNTED CONTINUE PLAY" OPTION IS ENABLED, THE PLAYER PAYS THE FULL AMOUNT FOR THE FIRST GAME AND THEN IS ALLOWED TO CONTINUE BY INSERTING ONLY 1 COIN. FOR EXAMPLE, IF THE GAME IS PRICED AT 2 COINS PER 1 PLAY AND THE "DISCOUNTED CONTINUE PLAY" OPTION IS ENABLED, THE PLAYER MUST INSERT 2 COINS FOR HIS FIRST GAME AND THEN ONLY 1 COIN TO CONTINUE HIS GAME.

Page 15

ELECTRONIC DRAWER ASSEMBLY

| Assy | Yagcspaues {OS | ELECTRONIC DRAWER ASSEMBLY TV yeecssesaa | MAIN EOGTGPOR=~=~*~*~<“~‘“‘“‘_S*S*SCS! [a | daa-oozeae | oan alae [3 | aagcapaede | SSO:*~*~“<‘*;C*i A Le eR 1a "| dae-oeza0e | | TRANSFORMER | 5 [aus , | TERMINAL BLOCK | 6 issuer; \ push EAGER CCC [oo | laasge2003 | as a y4e-902389 | | peice OoEP CSCS [> | Yaacge2002 | | AGRIGARY POWER GESPLY==SSC~C~S*~CS | 8 | 140-0200? | cre | RF. FILTER BOARD” « JAMA HARWESS oe |

Page 16

FIGURE A

Page 17

FIGURE A

OPERATION THUNDERBOLT GUN ASSY PARTS LIST

| sseses | seneeeceessssssessesseses | KEY DESCRIPTION PART NO |

Page 18

FIGURE B

Page 19

OPERATION THUNDERBOLT GUN ASSY PARTS LIST

HEX CAP NUT M4-3 (BLACK)

SIDE COVER (L) | --------------------+-------------------- BUTTON MD TORX SCREW M4X8 FIGURE B

F9991795 148-9130842 “consoles | 140-913083 | “c0200279 | 140-913044 “P9001794 “asain

Page 20

1S)

[<3] [24 a) oO we fa

Page 21

FIGURE C

OPERATION THUNDERBOLT GUN ASSY PARTS LIST

DESCRIPTION

s- FLANGE BUSHING 8OF- 9905

7 UNDERBASE | E9660328 146-913006

9 OIL-LESS FLANGE BUSHING 88F-8985

11 | PAN MD SEMUTH (S) M4X28

VARIABLE RESISTOR, PSET KNOB BSM

ial hla | 146-913614

E3006163 | 146-913016

F9981799 | 146-913017

| 148-913205

Page 22

a aundld

Page 23

FIGURE D

OPERATION THUNDERBOLT GUN ASSY PARTS LIST

149-913822

146-913267

148-913827

140-913218

I | 21 | OIL-LESS FLANGE BUSHING 80F-9965 F9061798 140-913032 WASHER TAP TIGHT M4X12 | 146-913030

GEAR BRACKET | £3066164 149-913633 |

GEAR (B) | E7868133 140-913069

Page 24

FIGURE D

OPERATION THUNDERBOLT GUN ASSY PARTS LIST

Page 25

NOTES

Page 26

NOTES

Page 27

NOTES