The Grid Header Installation
The Grid (version 1.2) (Midway, 2000) · Installation · 2 pages · original scan
Single Header Installation
OCTOBER 2000 Guo FEroypy
Before installing any header, all cabinets must be stable and level and in their final location. Turn off AC power and unplug line cords. Lay out all components before installation to ensure you know what each part is. Seek assistance when lifting headers atop cabinets. Observe grounding precautions. As an alternative to these instructions, you may assemble headers atop cabinets to avoid lifting after assembly.
1 2
Remove all items from carton. Inspect for damage. Align Retainer holes with holes at bottom of Header Housing. Fasten with tamper resistant screws. GROUND LUG Align Fluorescent Lamp Assembly with studs in rear of Header Housing. Fasten with ESN nuts, but leave EXTENDER a nut off the bottom left stud. CABLE TR SCREW
HEADER HOUSING
RETAINER
FLUORESCENT LAMP ASSEMBLY
Connect Extender Cable to main harness and run it through holes in top of cabinet and bottom of Header Housing. Connect it to Lamp Assembly. Place ground lug over bottom left stud on Lamp Assembly and fasten with ESN nut. “i i \ tt XO ESN NUT Align Housing with holes atop cabinet and fasten Z A
©, TR SCRE! with tamper resistant screws.
3 4 Fasten studs on left and right Walls to Header Bend artwork and Plexiglas to conform to shape of Housing with KEPS nuts. Fasten Wall flanges to Header Housing. Slide artwork and Plexiglas into cabinet with tamper resistant screws. Housing. Peel off transparent protective layer on each Wall. Align top Retainer with top panel of Header Housing and fasten with tamper resistant screws. RIGHT WALL 1 LEFT WALL UNUSED HOLE TR SCREW—, RETAINER: TR SCREW ~~“
The Grid - Header Installation Single Header
Triple Header Installation
Remove all items from cartons and inspect P!GHT rane
for damage. t
directly on top of the cabinets, rather than ‘
oming the assembly in step 2. . — = fs 4 erwise, align Bases on flat surface. AA Align Retainer holes with holes in front of Bases. Fasten with tamper proof screws from beneath. Align Center Braces on Base posts where Bases meet. Align right and left Panels on far ends of Bases. Fasten with ESN nuts. ESN NUT
LEFT PANEL
BASE
RETAINER \Gr SCREW
ESN NUT—_
Align Top Panel holes over left and right Pan- TORT ANE els and Center Braces. Fasten with tamper proof screws from above. Lift assembled header atop aligned cabinets with open side facing front. Align lower retainer to cabinet front. Attach Bases to cabinet with tamper proof screws. Connect Extender Cables to AC cables through holes in front tops of cabinets. EXTENDER
Bend artwork and Plexiglas slightly to conform to shape of header. Slide into front of assembly. LAMP ASSEMBLY Align Retainer holes with Top Panel holes and fasten with tamper resistant screws from GROUND LUG above. | Smooth out artwork from behind. = Hold Fluorescent Lamp Assemblies in position above headers to attach Extender Cables to Lamp connectors. Place ground lugs over studs on Lamp Assemblies and Base panels. Fasten with KEPS nuts. Place Fluorescent Lamp Assemblies on Top Panels with bulbs inside header assembly. Fasten with tamper proof screws. RETAINER:
KEPS NUT
Triple Header Midway Amusement Games, LLC