Tank TM-010 Bulletin B-0011 Monitor Jitter
Tank/Tank Cocktail (Atari/Kee, 1974) · Service Bulletin · 1 pages · original scan
from the ATARI CUSTOMER SERVICE DEPARTMENT
TANK "JITTER" PROBLEM, MONITOR MODIFICATION
The problem of jitter in the upper portion of the display, particularly evident in TANK I, has been carefully evaluated by the Atari Engineering Department. practical answer has been found to be a minor ‘modification te the monitor printed circuit The necessary component (inductor) is being supplied by Atari to purchasers of the Tank games, without charge, and should_ board, involving the addition of a small inductor,
“he installed into the monitor printed circuit board as described below.
: Ll Looking at the top (component side) of the monitor printed circuit board, é (see Figure 1), near the rear edge and left of center, locate the two components, inductor L2 and a 39ohm resistor R54, These components are installed in parallel.
- The modification consists of adding an inductor (supplied with this bulletin) in parallel to the existing components, L2 and R54. Tor greatest convenience, therefore, it is only necessary to solder the new inductor directly across R54 on the component side of the circuit board.
“eee Add New Inductor Here MONITOR PCB COMPONENT SIDE
nooese see”
Figuret The most