CATHODE RAY TOMES

Battlezone Cabaret DP-166-1st-01A

Battlezone (rev 2) (Atari, 1980) · Drawing Package · 1 pages · original scan

Page 1
Scan of page 1

COIN DOOR SCHEMATIC (034988-01) A REGULATOR AUDIO II PCB SCHEMATIC (035435-02 C)

INTERNATIONAL POWER SUPPLY SCHEMATIC (035887-01) A

wes va

A.

ATARI

Drawing Package Supplement

‘The RegulatoriAudio PCB has the dual functions of regulating the +5 VDC logic power to the game PCB amplifying the audio from the game PCB.

Regulator Circult

‘The regulator consists of voltage regulator 1, current

source power transistor Q3 and Q's bias transistor Q2. The

regulator accurately regulates the logic power input to the {game PCB by monitoring the voltage through high im edance inputs +SENSE and ~SENSE. The inputs are directly trom the +5 VOC and ground inputs to the game PCB. Therefore, the regulator regulates the voltage on the 1@ PCB. This eliminates a reduced voltage due to IR.

‘gam justed, the voltage atthe input of,

the game PCB will remain constant at this voltage.

Regulator Adjustment

  • Connect a voltmeter between +5 V and GND test points of the game PCB.
  • Adjust variable resistor R8 on the Regulator/Audio POB for +5 VDC reading on the voltmeter.
  • Connect a voltmeter between +5 V REG and GND on. the Regulator/Audio PCB. Voltage reading shall not be Greater than +55 VDC. If greater, try cleaning edge Connectors on both the game PCB and the Regulator/Audio PCB. 4, If cleaning PCB edge connectors doesn't decrease voltage difference, connect minus lead of voltmeter to GND test point of Regulator/Audio PCB and plus lead to GND test point of game PCB. Note the voltage. Now connect minus lead of voltmeter to +5 REG test point to

BATTLEZONE™ CABARET

Operation, Maintenance, and Service Manual arses [aL wor

onfeeaSee Poets seins

=f aS Poor pare oe: Hire ts fences hoe aes | hamese clreult 16 dropping the voltage: Troubleshoot t P| et the appropiate hamees wit or hamese connector Ag coe ‘Audio Circuit

Contents of this Drawing Package.‘anit Ech conii a TOSSaAY air

Rergepeiid pica t ‘gain of ten,

Game Coin Door and Power Supply Wiring DiagramsSheet 1, Side ASiva |Pea

Math Box Signature Analysis Procedures Sheet 1, Side B 4 = Microprocessor Sheet 2, Side A Senn Coin Door Inputs and Analog Vector-Generator Outputs Sheet 2, Side B Vector-Generator Sheet 3, Side A Auxiliary PCB Math Box, Switch Inputs and Audio Outputs Sheet 3, Side B

Reajauoio m ce (rn South s05435-08

Sheet 1, Side A DP-166-01 tst printing