CATHODE RAY TOMES

Food Fight Tech Tip TT-004-FF

Food Fight (rev 3) (General Computer Corporation (Atari license), 1982) · Document · 2 pages · original scan

Page 1

(teed ee

the ATARI FIRED SERVICE DEPARTMENT

Foon Fieut™

The following is a revised version of the JOYSTICK CALIBRATION informtion contained in Chapter 2, page ‘2-3 of the Food Fight game mammal (TM-229). This revision is applicable for both the cocktail and upright games. JOYSTICK CALIBRATION resets the joystick minimm and mximm values, and should be used whenever the NVRAM or joystick is replaced. When the JOYSTICK CALIBRATION test is selected for the upright game, the display appears as shown in Pigure 2-3. Hold the joystick steady for a full five seconds in each direction (left, right, up, and down). Press the start bitten twice to return to the min SEL? TEST mem (see Pigure in TM=229). When the JOYSTICK CALIBRATION test is selected for the cocktail game, the display appears as shown in Figure 2-4. The display shown in Pigure 24 indicates that the joystick is selected for calibration. Hold the Player-one joystick st: a full five secords in each direction (left, Tight, up, amd down). Press the start button and repeat the preceding Procedure for the joystick. the start button twice to return to the mem (see Pigure 2-! ‘TM-229).

IMPORTANT To store new joystick values, you mist return to the main SELF TEST mem and exit the self-test mode by turning the self-test switch off. If the self-test mde i is off or game power is removed) before returning to the main SELF TEST memi, repeat the joystick calibraticn

JOYSTICK CaLiHRAT ion JOysTick CALIBRATION HOLG JOYSTIck [Nm cach ciac. an HOLO JOYSTICK IN EACH OLAEC: fon FoR FIlve seconas fom FIvE seconos Push sTagT 2 TO cauinearc PLavesR I uorsTick euse cTaaT | TO cro Pus sTag@T 1 To ENG

Figure 2-3 Joystick Calibraticn Figure 2-4 Joystick Calibration Display (Upright Game) Display (Cocktail Game)

FOR FURTHER INFORMATION CALL: (st $38-1611 Greece —— (aoe) 748-2900 19178 caveay

Page 2

Page 2

change game option settings, or to clear the high scores or statistics. Press the THROW button to cycle through the values on the current row (indicated in ved). Change the current row using the joystick or the two-player start button. Press the cne-player start button to end this display and return to the min SEL¥ TEST mem. When the self-test awitch is turned off, the displayed option settings become the current settings. To restore option settings or to clear high. scores or statistic values, select the desired row and press the THROW button. RESTORED or CLEARED is then displayed.

IMPORTANT

interrupted (i.e., the self-test switch is turned off, or game power is removed) before returning to the min SELF TEST memi, repeat the preceding for

The opticns and settings available are shown in Table 2-5.

Table 2-5 Option Settings

Page 2