Turtles
Turtles (Konami (Stern Electronics license), 1981) · Manual · 9 pages · 10 sections · original scan
This page carries no recoverable text. It is a drawing or a photograph. See the original scan.
The object of the game is to reach the top of the building with the Turtlelets. To play the game, pick up the Turtlelets from the different levels of the building, while protecting yourself from the attacking Beetles. To advance to a higher level you must first pick up all the Turtlelets from the level you are on.
Use the turtle to examine the Mystery Squares. The Mystery Squares can contain either a Turtlelet or a attacking Beetle. If it contains a Turtlelet it will climb on your back, and you must bring it to the House before you can pick up another one. The House only appears after you have picked up a Turtlelet. Picking up the Turtlelet is worth 100 points, bringing it to the House is worth 150 points.
To disable an advancing Beetle use the Bug Bomb. When the Beetle is disabled you can walk over it to go in the opposite direction. A disabled Beetle is worth 50 points. Picking up the flashing star in the screen gives you three extra Bug Bomb.
1.1
1.2
1.3 SECTION 1 INSTALLATION
INTRODUCTION
This game has been STERN final tested and is ready to play, but on all games there are some items that must be checked after shipment. Making these visual inspections may avoid time consuming service work later. Minor troubles caused by abusive handling in shipment are unavoidable, such as cable connectors that may have become loosened. Check ALL CONNECTORS on the game to make sure they are firmly seated. Check to make sure that the game control boards are firmly seated, Examine the exterior of the game cabinet for dents, chips or broken parts. Check all major sub-assemblies, control panels, and T.V. monitor to make sure that they have not loosened up during shipment.
VISUAL INSPECTION BEFORE PLUGGING IN LINE CORD
- Check the transformer for any foreign material shorting across wiring lugs.
- Check that fuses are firmly seated and making good contact. Line fuse (3 AMP SLO-BLO) located on the transformer board, fluorescent lite fuse (1 AMP SLO-BLO) located on the fluorescent board, and 3 circuit board fuses - located on the power supply board (See drawing B).
- Check the T.V. for any foreign material that could cause shorts (VISUAL INSPECTION ONLY).
- Check game boards for any foreign material that could cause shorts. Make sure ribbon cables are pushed into circuit boards.
ON/OFF POWER INTERLOCK SWITCHES
- The on/off power switch is located on the top right side, 12 inches from the front.
- There are two interlock main power switches by the front door and one by the back access panel.
- Interlock switch interrupts all power from game except service outlet. Interlock switch can be locked in “on” position by pulling stem out when servicing game.
1.4 GENERAL INFORMATION
1. On front door there is a service switch. Depressing this switch will coin machine without advancing coin counter (if installed).
Wiring for a counter is inside the front door on the left hand side of cabinet. (6 VDC COUNTER).
There are two coin chutes on the front door that are connected in parallel. (Note: They cannot be adjusted to work separately, see Dip Switches 4 and 5 below).
Game adjustment switches are located on CPU board. (See below for adjustments).
The electronics package used in SCRAMBLE is the same for stand-up model and cocktail table model. (They can be interchanged if Dip Switch #3 is changed on CPU board).
Volume control for electronic sound is located on CPU board.
Power supply board has an adjustment (See DWG 8B) for the +5 VDC regulator, this MUST BE SET BETWEEN +5.0 VDC and 5.25 VDC.
The crosshatch, seen during power-up, is used for convergence on the monitor. To get a constant crosshatch hold the player one start button during power up.
GAME ADJUSTMENTS
SWITCH 1 2 ROCKET OFF OFF Freeplay
| OFF | ON | 5 |
| ON | OFF | 4 |
| ON | ON | 3 |
SWITCH —_ 3 OFF Table ON Up Right
Cont'd. on next page.
+5V TRANSISTOR MOUNTED ON BACK OF BOARD
Co
R2
ADJUST
Ps-1200 => TP2 +12V
= TP3 GND
= TP4 +5V
> 7) Ss ) ea TP1 -5V
sav + -5V GND +5V
ai
POWER OUT
(5 | | | Nor UseD (6
+5V key, + i KEY - GND 3 KEY GND + GND GND GAME ADJUSTMENTS CONTINUED
switcH 4 5 coins
| OFF | OFF | 4 |
| OFF | ON | 3 |
| ON | OFF | 1 |
| oN | ON | 2 |
ROCKETS (1 o 2) CABINET MODEL (3 | = 4)o coin switc | o ON
F2 FS 4 AMP_2 AMP 1 AMP
cR1 DIODE BRIDGE
AC GND GND
GND GND
TRANSFORMER
> PLAY
RIBBON CABLE
CPU BOARD
HEAT SINK inn LOUD-TURN CLOCKWISE ~~!
VOLUME CONTROL
O00
PROGRAM E-PROMS

This page is a drawing, shown as the original scan.
HSA-1200
2N6226 REVISIONS
OESCRIPTION
ISSUED €.7, 00922.
v2 ro swucl & | i] ]
4As8
| ative! < I | ce’: | Re | 1 | |
| 4 | ! | I | 15,000 wFD | ct | + 5v REG. |
| | | | | 16. |
MFO
| | | | | ‘S +5, REG. |
7 3 RT Yin
| | | | | cap | fe | vet | 2 | RRs | ew |
| u | eS | ouM3i7T | Vout | ||||
| | | wns3o | 2a 38 | __Ady | von | 620n | ||||
| CRS. | y | + | |||||
| 18S | pe | Sey | |||||
| Re | R2 | tev | |||||
| 3 | 2 | Sint | s | ||||
| 1 | 1 | 6200 | Ka | ||||
| aX | Hav REG | | |
FOR 240V Line,
AND @ SHOU CO coo tint | ! \ 3 +12v res
| + | T Nott | a |
| 4 | e | 3, |
NoTes_ [E> SHOULDER WaSne REQUIRED ON 1 | ! MOUNTING STUD + TED cenenar wistawants 6.3 vAMS | TO GEN. TLL.
| 2 | u | cre | | Sy cova |
<3 1
| 1odemros: | 9 feo | | | 7308 | 2fiieo § SR3 | lz |
| 103 VRMS | 35V | +) lev | Wa | >> |
TO MONITOR
3 —_o
POWER TRANSFORMER 160-26-+
er i" ELECTRONICS, INC. 1 STERIMT peceoueinc, SCHEMATIC ,POWER SUPPLY PC. BOARD 34C-978-S
G F Cc B A
+5V
GND
BLUE §=(B. GREEN AlZ. RED Ald SYNC 2562320, AMPH SIK gS
| SPEAKER | 82) | aig wor) | "4 | Frou |
ie 5) 25
| 7. | 8 | ed |
iA MSISIEL
| +12V | 1® ja P Fe | F osur |
| 100uF | 47uF | 0 35v |
25v 25v
O.0luF 50V
-5v
2SCIBIS counrer BIL) Cg sik oo =
| CON | CRED | ual | |
| COUNTER. | Cp | Sik | i) |
B (280361
7 —ts_
| COIN! | ~=CAIO-Y | oe | per |
poe 1K 220
| cON2 | BIO | “Bas |
1KelB your IPLEFT. CBR co saps
IP RIGHT Caaf
IP SHOOT -
SERVICE 2
NO USE - par
| Pa’ 220 | FOF | gy | fad |
| 2p up | CB > | TOF 54? aass |
- i
RESET- 087 —&®) 0B6—@) Bs —® r4—O 0B3—@) B2—S) DaI—®)
Xtal 14,318 MHZ io
8255 1D
RESET ec
Aa Aq
AY-3-840)
cHals— cHa2 CHB) CH32
GND CKB
IK 8 a 15% — 7 7 4aH)S— RD" TR “itaaysar’ 1/9. IZ REO} isan) HEREO” ToRG|eoL a 5 . Tof4n )— ioREG 804, FSI Ma>ol2 AEMREO™ 5 ‘ ae — 1532
AS —Tofan) 2 avis la [a A —T Sian) o—avia _ AVIS 5 i332 9 TERRE a | 13]3H)-—AVI3- RD* 2(3h)2—avi2 NI
- NOTES — 0; TANTALUM ELECTROLYTIC CONDENSER.
@; MMAR CARACITOR. ©: ELECTROLYTIC CONDENSER. NO MARK CERAMIC CONDENSER.
CBE + 36 PIN connector, Bis parts side,
@ 5 34 PIN CONNECTOR, CD : 2 PIN connecror. t 3 ec, +5¥
+ GND, OV
KT- 4108-1
Toerle
This page reads as a drawing: its text was drawn rather than typeset, and comes out in fragments. See the original scan.