Raiden DX Operators Manual (Jap)
Raiden DX (UK) (Seibu Kaihatsu, 1994) · Manual · 4 pages · original scan
SEIBU KAIHATSU INC.
Ot
OLYWYARIS— EDX
Near anes OPERATOR’S MANUAL
EDGE CONNECTOR
SOLDER SIDE (+#i@)} NO | NO | PARTS SIDE(# a)
| GND | A | 1 | GND |
| GND | B | 2 | GND |
| +5V | Cc | 3 | +5V |
| +5V | D | 4 | +5V |
E 5
| +12V | F | 6 | +12V |
H 7
| COIN COUNTER 2 | J | 8 | COIN COUNTER 1 |
K 9
| SPEAKER (-—) | L | 10 | SPEAKER(+) |
M | ll
| VIDEO GREEN | N | 12 | VIDEO RED |
| VIDEO SYNC | P | 13 | VIDEO BLUE |
| SERVICE SW | R | 14 | VIDEO GND |
S | 15
| COIN IN 2 | T | 16 | COIN IN 1 |
| 2P START | U | 17 | 1P START |
| 2P UP | Vv | 18 | 1P UP |
| 2P DOWN | w | 19 | 1P DOWN |
| 2P LEFT | xX | 20 | 1P LEFT |
| 2P RIGHT | Y | 2i | 1P RIGHT |
| 2P PUSH | | Z | 22 | 1P PUSH I |
| 2P PUSH 2 | a | 23 | 1P PUSH 2 |
b | 24 c 25 |
d 26
| GND | e | 27 | GND |
| GND | f | 28 | GND |
OJAMMA#&AR =JAMMA STANDARD
O9FHiM VERTICAL SCREEN
OAYvbha—)beSA)Jb =CONTROL PANEL
8Way Joystick PUSH 1 PUSH 2 “> SHOT BOMB WS wah) tees) a
OiR POWER SOURCE
F12V0 TA
(PARTS SIDE)
O VOL
DIP 2 JAMMA DIP 1
This page reads as a drawing: its text was drawn rather than typeset, and comes out in fragments. See the original scan.
dS EAA
- PCR—FORRO ATU, MOWMLILY Fe Wo Ch6fToT FSt.,
- RRP THALYS — Vv HI DIURIG GO, MELT CO Ursa Frid, BRIER UT PRP CH TBAT ISAT RIK LAO ET,
- ERIL—BB Sy TY So PP VP ANTI), FAR—ME CHIBMEL EY FOoLYa—bOWMACLOL TO CHAT LIED PSU, EMAIL Sy FY — ISHPSTLOT PSO, 4, PCR—P PHT T SBR IIE, ABY SY PLP EVV TA RETCAA, BER fi TEE AR RTE MALO LI OIE PSU,
POINTS OF CAUTION . Always make sure the power is turned off before installing or removing a PC board. . If the serial number seal affixed to this board has been removed, or alteration without consent has been made, then in the case of malfunction, even within any warranty period, will result in loss of subjection to warranty or onus. . The circuits have been partly battery backed-up. Please desist from carrying out conductivity inspections with such tools as circuit testers as these can cause short circuits. And never remove the batteries. . When transporting PC boards, please wrap them in sponge rubber or bubble wrap and place them in cardboard boxes. Take care to prevent exposure to strong shocks or jolts.
SEIBU KAIHATSU INC., Amat C4 DRE T101 RRA BR =e By 2-20-1 2-20-1 Misaki-Cho Chiyoda-Ku, Tokyo 101 TEL.03(3238) 9169 FA X.03(3238) 9187