CATHODE RAY TOMES

Skins Game Joystick Calibration

Skins Game (1.06) (Midway, 2000) · Document · 1 pages · original scan

Page 1

CALIBRATION NOTICE 16-11128

DIS Liddle

Proper joystick calibration is essential to game play. When you first turn your Skins Game on, you should see a calibration screen and have an opportunity to reset potentiometer limits. Do not skip test. You must reset pot limits to ensure accuracy.

If you do not see the calibration screen:

  • Enter Menu System by pressing TEST pushbutton on Test Switch Bracket. Wait 30 seconds.
  • Select TESTS, then select CONTROLS TEST. You will see the screen below.

COIN MECHS MISC 123 4 TILT VOL+ svc BILL TEST VOL—

e 3A3 | OBA START OBA Keypd VIEW CilY O7F 1C5 304 123 CLUB + Ctl x 456 CLUB — 789 AIM LEFT *O# AIM RIGHT LAMP ON

GRN=ok RED=Sw ON. YEL=Sw maybe. To activate LAMP, press START To reset pot limits, Press and hold START To activate coin counter, Press TILT Switch. To return to menu, Press and hold VIEW or CREDIT

  • Press and hold START button until center box and numbers surrounding it flash and turn red.
  • Pull joystick down as far as it will go. Observe that the dot in the box follows the movement of the joystick.
  • Pull joystick left as far as it will go, then right as far as it will go. Observe that the dot movement reflects joystick movement.
  • Release joystick to neutral position. Numbers turn green when calibration is done.
  • Press and hold VIEW button to return to TESTS menu. Press and hold VIEW again to return to Main Menu. Select EXIT TO GAME and press START button.