CATHODE RAY TOMES

Asteroids Deluxe DP-165-1st-01A

Asteroids Deluxe (rev 3) (Atari, 1980) · Drawing Package · 1 pages · original scan

Page 1
Scan of page 1

INTERNATIONAL X-Y POWER SUPPLY WIRING DIAGRAM (035887-01 A)

U.S. X-Y POWER SUPPLY WIRING DIAGRAM (036352-01

Drawing Package Supplement

to

ASTEROIDS DELUXE™

Operation, Maintenance and Service Manual

Contents of this Drawing Package

Game Wiring Diagram, Coin Door and Power Supply Sheet 1, Side A Microprocessor Sheet 1, Side B Video Generator Sheet 2, Side A ‘Switch Inputs, Coin Counter, LED and Audio Outputs Sheet 2, Side B

AL ATARI

© 1981 tae, ‘Sheet 1, Side A DP-165-01 1st printing A) REGULATORIAUDIO | PCB SCHEMATIC (034485-03 A)

RogulatoAudio | PCB ‘The Regulator/Audio | PCB has the dual functions of requ: lating the +5 VDC logic power to the game PCB and ampli fying the auio from the game POB,

Regulator Circuit ‘The regulator consists of voltage regulator Q1, current source power transistor Q3 and Q3's bias transistor G2. The regulator accurately regulates the logic power Input to the ‘game PCB by monitoring the voltage through high impedance inputs +SENSE and ~ SENSE. The inputs are directly from the. +5 VDC and ground inputs to the game PCB. Therefore, the regulator regulates the voltage on the “This eliminates a reduced voltage due to IR Buildup on the wire hamess between the regulator and the ‘game PCB. Variable resistor Ris adjusted for the +5 VOC. ‘on the game PCB. Once adjusted, the voltage at the input of, the game PCB will remain constant at this voltage.

Rogulator Adjustment

  • Connect a voltmeter between +5 V and GND test points of the game PCB,
  • Adjust variable resistor R& on the Regulator/Audio | PCB for +5 VDC reading on the voltmeter.
  • Connect a voltmeter between +5 V REG and GND on the Regulator/Audio | PCB. Voltage reading must not be ‘greater than. +55 VOC. It greater, try cleaning edge ‘connectors on both the game PCB and the Regular toWfAugio | PCB.
  • If cleaning PB edge connectors doesn't decrease voltage difference, connect minus lead of voltmeter to GND test point of Regulator/Audio | PCB and plus lead 10 GND test point of game PCB. Note the vot Now connect minus lead of voltmeter to +5 REG test point on Regulator/Audio | PCB and plus lead to +5 V {est point on game PCB. From this you can see which hhamess circult is dropping the voltage. Troubleshoot the appropriate harness wire or harness connector.

‘Audio Circuit The audio circult contains two independent audio ampli fiers. Each amplifier consists of a TOAZOG2AV amplifier with again of ten

<Toonates atest point

U.S. COIN DOOR SCHEMATIC (034988-01)

BRITISH-MADE COIN DOOR SCHEMATIC (037050-01 A)