CATHODE RAY TOMES

Asteroids ST-143 1st Printing Backdoor Sheet

Asteroids (rev 4) (Atari, 1979) · Backdoor Sheet · 1 pages · original scan

Page 1

ste Ast pri

IMPORTANT NOTE TO OPERATORS: If the operation, maintenance and service manual was not included in this game when you unpacked it, contact your distributor to get a free copy. (All Atari and Kee Games manuals for coin-operated games also include a complete illustrated pars catalog.) To change toggle positions of the switch assembly, you need not remove the game PCB. The switch, usually colored blue, is easily accessible when the game PCB is mounted in piace.

When changing the options, verify proper results on the TV Monitor display during self-test. A switch toggle in the on position

is indicated by a 0 for that switch on the TV monitor display. A switch

in the off position is indicated by a 1.

OPTION SWITCH SETTINGS

RESULTS IF TEST

INSTRUCTION PASSES RESULTS IF TEST FAILS

Set seittest_| TV monitor displays | RAM FAILURE is indicated by a sequence of from 1 to 6 tones. A low-frequency switch to on posi-| picture as shown to | tone is neard for each good RAM chip. A much lower frequency is heard for a tion as shown to | right failing RAM chip. The sequence stops with the last failing RAM chip. To restart right. the sequence, press the Reset pushbutton on the game PCB or set the self-test switch to off, then again to the on position. Identify the bad RAM chip with table below. Example: Three tones, then a tone of much tower frequency indicates failure of RAM chip Ra. Toggle settings of B-toggle switch Suggested

‘on game PCB Option Setting

12345678
ONONEnglish Language
OFFONGerman Language
ONOFFFrench Language
OFFOFFSpanish Language

SWITCH LEFT COIN MECH RIGHT COIN MECH ON 4-Ship Game

RAM CHIP LOCATION TOGGLE 1 MULTIPLIER MULTIPLIER OFF 3-Ship Game ”

1D2ONLeft Coin Mech x 1Pa

2 £2 OFF Left Coin Mech x 2 4 Re OFF ON Right Coin Mech x 4

3MaONONRight Coin Mech x 7-
5NaONOFFRight Coin Mech x 5
6PaOFFOFFRight Coin Mech x 6
ONONFree Play

OFF ON = 1 Coin 2 Plays

ONOFF1 Coin 1 Play-
OFFOFF2 Coins 4 Play

ROM/PROM FAILURE is indicated by two lines of numbers in the upper lefthand corner of the display. The number on the first line indicates the failing ROMIPROM chip(s). Identify the bad ROM/PROM with table below. The number on the second line indicates the failing data bit of the failing ROM/PRON. Identify the bad bit with the second table betow. If more than one bit is failing, the displayed numbers) are hexadecimal combinations of the numbers shown below. Examples:

  • If bits 02 and 03 fait, C is displayed.
  • If bits 02, 03 and D7 fail, BC is displayed.
  • If bits 04 and DS fail, 30 is displayed.
  • If bits D1, 03, DS and Dé fail, 6A is displayed

DISPLAYED NO. FAILING ROM/PROM

° NIP

Photograph above shows toggles 1, 2, 47

‘on, and toggies 3 and 8 off.

F2, Ht FA Fa, au

REGULATOR ‘AUDIO PCB

VOLUME CONTROL

1 DO o1 b2

Da DS D6 o7 VOLUME DECREASE: TURN CLOCKWISE

SELF-TEST ‘SWITCH BE8saen

RAMSEL SIGNAL FAILURE is indicated by PAGE SELECT ERROR message at lower middie of display. Lo | ASTEROIDS GAME PCB ATARI’ 1 PLAYER START and 2 PLAYER START LEDs are lighted. Highpitched click for gach activated switch.

  • Activate all control panel and coin door switches. 1 PLAYER START and/or 2 PLAYER START LEDs not lighted.

High-pitched click sound is not heard for any particular switch,

POWER SAFETY ONIOFF SWITCH INTERLOCK