CATHODE RAY TOMES

Centipede DP-182-5th-01A

Centipede (revision 4) (Atari, 1980) · Drawing Package · 1 pages · original scan

Page 1
Scan of page 1

Power Supply Schematic (037669-01 C)

Regulator Audio Il PCB Schematic (035435-02 )

Regulator/Audio 1! PCB ‘The Regulator/Auio l PCB has the dual functions of reg- Ulating the +5 VOC logic power tothe game PCB and am: plifying the audio from the game PB.

Regulator Circuit The regulator consists of voltage regulator Q1, power pass transistor Q3 and Q3's driver tansistor Q2. The regulator accurately regulates the logic power input to the game PCB by monitoring the voltage thrcugh high-impedance in puts +SENSE and SENSE. The inputs are directly from

pass transistor Q3 and Q3's driver tansistor Q2. The regula the +5 VDC and ground inputs to the game PCB. Therefore,

the regulator regulates the voltage on the game PCB. This remain constant at this voltage

eliminates a reduced voltage due to IR loss in the wire hhamness between the regulator and the game PCB, Variable resistor RB is adjusted for the +5 VOC on the game PCB. (Once adjusted, the voltage atthe input of the game PCB wil remain constant at this voltage. Regulator Adjustment

1. Connect a voltmeter between +5 V and GND test points

of the game PCB.

  • Adjust variable resistor RB on the Regulator/Audio Il PCB for +5 VDC reading on the voltmeter.
  • Connect a voltmeter between +5 V REG and GND on the Regulato/Audio Il PCB. Veltage reading must not be greater than +5.5 VDC. it greater, try cleaning edge Connectors on both the game PCB and the Regula toriAuaio Il PCB. 4 “leaning PCB edge connectors doesnt decrease vot

age difference, connect minus lead of voltmeter to GND

test point of GND test point of gar Now connect misus ead of vlimetor + SREG tost point on Regulator/Audio ll PCB and plus lead to +5 V {est point on game PCB. From this you can see which, hamess circuit is dropping the voltage. Troubleshoot the appropriate harness wire or harness connector.

‘Audio Circuit

The audio circuit contains two independent audio ampli

fiers. Each amplifier consists of a TOAZ002AV amplifier wth an effective gain of 22.

<1 Denotes a test point

Sees A | Centipede Wiring Diagram (037432-01 c)

ATARI

Drawing Package Supplement ky

Centipede”

Operation, Maintenance and Service Manual

Contents of this Drawing Package

Game Wiring Diagram, and Coin Door, Regulator/Audio I! PCB, ‘and Power Supply Schematics ............... Sheet 1, Microprocessor, Sync Generator, CAT Box Set-Up and Power Inputs Playfield Address Selector, Playfield Memory and Festa Playfield Code Multiplexer . ‘Sheet 2, Side A Coin Counter Input Circuitry, Switch Inputs, Video Outputs and Mini-Trak Ball™ Circuitry ................. ‘Sheet 2, Side B

Ose comrncnen coer ‘Shoot 1, Sido A Dp-1e261 5th printing Contipede