Pit-Fighter CO-357-02 1st Printing
Pit-Fighter (Tiger) (Tiger Electronics, 1991) · Change Order · 1 pages · original scan
O-357-02 Ist printing A
ATARI
PI FIGHTER
Revised Grounding Method for Control Panel Assembly
Supplement to the Operator’s Manual
Your Pit-Fighter game’s control-panel ground wire has been revised for operator convenience. The Pit-Fighter Operator’s Manual (TM-357), page 1-2, step 4, describes in the control panel installation procedure how you should attach the ground clip to the power supply base. That step should now read as follows: able, so be sure to match wire colors. Plug the third harness connector into the game PCB connector located near capacitors C42-C44, Plug the fourth (ground) wires together at the Fast-on connectors. This step is very important, since these wires ground the control panel.
- Plug the two control panel harness connectors into the game harness inside the drawer. These connectors are interchange- For other information on this game, please refer to the Pit-Fighter Operator’s Manual that was included with your Pit-Fighter game.
If you need technical assistance, cali your distributor or Atari Games Customer Service at one of the following locations; United States: (408) 434-3950 Atari Games Corporation, 737 Sycamore Drive, Milpitas, CA 95036-1110 (Monday-Friday, 7:30 a.m—4:00 p.m. Pacific time)
Europe: 062-52155 Atari Games Ireland Limited, Tipperary Town, Ireland (Monday-Friday, 9:00 a.m.—5:30 GMT)