Scramble
Scramble (Konami, 1981) · Manual · 9 pages · original scan
SCRARBLE
SCRAMBLE
Object of game is to invade five SCRAMBLE defense systems to destroy THE BASE.
Use joystick to move up, down, accelerate, and decelerate.
Use Laser and bombs to destroy rockets, fuel tanks, mystery targets and UFO's.
Hit fuel tanks for extra fuel for AIRCRAFT.
Bonus AIRCRAFT at 10,000 points.
SCRAMBLE
SECTION 1 INSTALLATION
INTRODUCTION
This game has been STERN final tested and is ready to play, but on all games there are some items that must be checked after shipment. Making these visual inspections may avoid time consuming service work later. Minor troubles caused by abusive handling in shipment are unavoidable, such as cable connectors thay may have become loosened. Check ALL CONNECTORS on the game to make sure they are firmly seated. Check to make sure that the game control boards are firmly seated. Examine the exterior of the game cabinet for dents, chips or broken parts. Check all major sub-assemblies, control panels, and T.V. monitor to make sure that they have not loosened up during shipment.
VISUAL INSPECTION BEFORE PLUGGING IN LINE CORD
- Check the transformer for any foreign material shorting across wiring lugs.
- Check that fuses are firmly seated and making good contact. Line fuse (3 AMP SLO-BLO) located on the transformer board, fluorescent lite fuse (1 AMP SLO-BLO) located on the fluorescent board, and 3 circuit board fuses - located on the power supply board (See drawing B).
- Check the T.V. for any foreign material that could cause shorts (VISUAL INSPECTION ONLY).
- Check game boards for any foreign material that could cause shorts. Make sure ribbon cables are pushed into circuit boards.
ON/OFF POWER INTERLOCK SWITCHES
l. The on/off power switch is located on the top right side, 12 inches from the front.
- There are two interlock main power switches by the front door and one by the back access panel.
Interlock switch interrupts all power from game except service outlet. Interlock switch can be locked in "on" position by pulling stem out when servicing game.
GENERAL INFORMATION
1. On front door there is a service switch. Depressing this switch will coin machine without advancing coin counter (if installed).
Wiring for a counter is inside the front door on the left hand side of cabinet. (6 VDC COUNTER)
There are two coin chutes on the front door that are connected in parallel. (Note: They cannot be adjusted to work separately, see Dip Switches 4 and 5 below)
Game adjustment switches are located on CPU board. (See below for adjustments)
The electronics package used in SCRAMBLE is the same for stand-up model and cocktail table model. (They can be interchanged if Dip Switch #3 is ¢hanged on CPU board)
Volume control for electronic sound is located on CPU board.
Power supply board has an adjustment (See DWG B) for the +5 VDC regulator, this MUST BE SET BETWEEN +5.0 VDC and 5.25 VDC.
GAME ADJUSTMENTS
SWITCH 1 2 ROCKET
OFF OFF Freeplay
| OFF | ON | 5 |
| ON | OFF | 4 |
| ON | ON | 3 |
SWITCH
OFF: - Table ON Up Right
Cont'd. on next page.
GAME ADJUSTMENTS CONTINUED
SWITCH
| 4 | 5 | COINS | PLAY | |
| BEE | ofr | : | H | RIBBON CABLE |
| ON | OFF | 4 | ; | CPU BOARD |
ON ON LOUD-TURN CLOCKWISE
ROCKETS (1 fo 2|/ co VOLUME CONTROL CABINET MODEL (3 | CI 4|/c COIN SWITCH 6|
NoT useD (6 LCI
ON
HEAT SINK
PROGRAM E-PROMS
Ql +5VDC 2N6121
5 VDC ADI er (ADJUST BETWEEN 4.8 VDC TO 5.2 VDC)
TP4 +5VDC i
-——-1p3 end
I—_1p2 +12VDC I—_p1 -svve BR2 +12VDC 7812
FUSE F3 LAMP
_ FUSE F2 2AMP FUSE Fl 4AMP
+5 VDC BRIDGE RECTIFIER
DESCRIPTION
ISSUED €.1, 00832
HEAT SINK 8" NOT AT @ROUND POTENTIAL. SHOULDER WASHER REQUIRED ON MOUNTING STUD,
GENERAL INSTRUMENTS. 6.3. VRMS TO GEN. TLL.
193 VANS ITO MONITOR
POWER TRANSFORMER 180-14
ELECTRONICS, INC. 1725 Orversey Parkway, Chicago ios 60614 SCHEMATIC, POWER Jolt cree Serice Avsistance 600) 621.6424 SUPPLY PC. Bo, ARD 340 -849-8
| 2 | x | = | 2 | oe | = |
| Rese | g | 28 | g2 | 953 | |
| ser | OBESESE | Gobh840590 | |||
| —5VCAT > - 5 | ca | 2 | x | ||
| REC | —® | ZSSR2 828 ERRPE SS 853 | Avo |
gs
| GREE | @ | cK |
RED_A 14 _)-—-@ SINCC BIE )—@ cusTon 162 “ih 1K
| COINI | #2 | F | foe | baa |
1E10 " 7 3} 28 8 1EI2 “8 Le 10S Lal t ca 20 Lava cusre im +cke o— 475) EE x i i joo 00022 uF woe ynos 2) @ t-Av3
| xe—4 | lo | cre |
ea ‘
| x0 —2| | [2 | ‘RESET |
L RESETS.
bAVS + KB
‘PUP
CBZ) COIN Xtal 14 31BMNZ 2802320 x a9 SPEAKER 9 lt 5 5K ‘ive vR200 |19 $a te an Toisue, yas? |; | TA ra5is16L. sug P ‘a
- on
—NorES — @ ; TANTALUM ELECTROLYTIC CONDENSER. GOs MYLAR CAPACITOR, © ELECTROLYTIC CONDENSER, NO MARK 5 CERAMIC CONDENSER. CBZ ; 36 PIN CONNECTOR. B is parts side.
@ + 50 PIN CONNECTOR, AY-3- 89/0]
| ae | lay | t | 3 vec, +5V |
a 4 3GND, OV
soo STERN * ELECTRONICS, INC. SCRAMBLE PRS 725 Sn Pane, ego vino ie '33A-105 (L-1200-1) {or Fre Senice Asistance @o0 621.424 soso —4
This page reads as a drawing: its text was drawn rather than typeset, and comes out in fragments. See the original scan.