CATHODE RAY TOMES

Attack Manual

Attack (set 1) (Exidy, 1977) · Manual · 8 pages · 10 sections · original scan

Page 1

ATTACK

BY Exidy

SERVICE MANUAL

Page 2

WARRANTY

EXIDY warrants all TV monitors and moving mechanical parts for a period of 90 days from date of purchase.

All printed circuit boards are warranted for a period of one full year from date of purchase.

Any questions regarding part replacement or service on failed parts will be dealt with on an individual basis.

Please contact your local EXIDY distributor for service. Our distributors are authorized to deal directly with the EXIDY service and parts departments.

Page 3

SECTION PAGE

Illustrated Parts Breakdown....... seseressecceeoreees 1

System Block Diagram. ... cece eas see rece ences eceenecree 2

Adjustments... ccsceccencrececeesrecceeserssesererseees 3 Power Supply Adjustment Volume Adjustment .Game Time Adjustment

Troubleshooting TipS....cscscccccsvevscacecsseseceare 4

P.C. Board Connector Pinout. ..sssesceeesecsececeeeere 5

P.C. Board Logic Diagram...... secesee Back of Manual

Page 4

SECTION PAGE

Illustrated Parts Breakdown......+ seesceesesesvevsees 1

System Block Diagram.....ecsecec cer cenesecseveecerscee 2

Adjustments......eeeeeee Power Supply Adjustment Volume Adjustment .Game Time Adjustment

Troubleshooting TipS....cssscccrecccrecccccerececcers 4

P.C. Board Connector Pinout..cccssccccvcerevosseecnes 5

P.C, Board Logic Diagram.....cseeseeeeeeeeeee Back of Manual

Page 5

ATTACK

SYSTEM BLOCK DIAGRAM

CONTROL

PANEL

TV

MONITOR

10 VAC GO hz

AC INPLIT

INTERLOCK

Page 6

Adjustments |

A. Power Supply Adjustment

Proper operation of this game is absolutely dependent on proper adjustment of the +5vdc power supply.

Before attempting to operate or troubleshoot this game, measure and adjust, as necessary, the +5vdc power supply voltage.

Measure voltage with meter leads contacting +5vde and ground traces on P.C.B., near the 6 pin connector.

The power supply voltage is set at the factory, but shocks due to shipping and handling may cause this setting to vary.

B. Volume Adjustment

Sound volume is adjustable using the pot on the P.C.B. nearest the 22 pin connector.

Game time (length of game) is adjustable using the pot on the P.C.B. nearest the 6 pin connector.

Page 7

—Game blows fuses

Game has sound but no picture Repair or replace __

Game has picture but no sound

Game does not start with coin Check output of power supply for +5vde. If not present, replace

No +12vde Check power supply har-

| Bad P.C.B, Bad coin mechanism

All controls completely inoperative

Some controls inoperative

Game is erratic. Seems to work OK sometimes, other times not. ena Game is static sensitive

a Ground wire to control —{harness open (disconnected) |

Bad leaf switches in control panel ness. Wire attached to iL Replace | Repair or replace Check microswitch and

Repair

Replace (even if just bent). Once bent, switch is unreliable, 4. ___

Low +5vde power Adjust power supply. Measure voltage with test leads on P.C.B. (near 6 pin connector). | Repair or replace

Nearby devices generating high voltages and/or high frequencies. Solder 12" long 22 awg. insulated wire to pin 20 of 32 (P.C.B. 22 pin connector), Leave one end hanging loose, taking care that wire is properly insulated. If game shuts off too easily then, trim the wire shorter as _____| necessary,

Page 8

P.C,

«

£3 ao 3. ran +5V 5. 6S GND

  • +12v (and one side of S
  • SPKR (direct)
  • GND 4, 5. 6.
  • «+ (ship
  • + (ship
  • . (ship
  • «(ship 1L. «eee (ship
  • . (ship
  • - (plane
  • - (plane
  • *PLN SPD FST...(plane
  • PLN RCCW.......(plane
  • +*PLN RCW.....-..(plane
  • COIN............ (coin
  • GND 20, ANT. .ceeeeeeeess (amti-
  • VIDEO RETURN
  • TV VIDEO ATTACK

BOARD CONNECTOR PINOUT

PKR)

move left) move right) gun right) gun left) button fire) button fire) button fire) button fire) speed fast) rotate counter~clockwise) rotate clockwise) drop)

static antenna)