CATHODE RAY TOMES

Chequered Flag

Chequered Flag (Konami, 1988) · Document · 5 pages · 3 sections · original scan

Page 1

KONAMI;

GERED

™ c KONAMI 1988

Q oa - a Af sie

) OPERATOR'S

=] MANUAL

WARNING ‘CHEQUERED FLAG: is an original game developed by KONAMI Industry Co. Ltd.. KONAMI! Industry Co.. Ltd. reserves all the copyrights, trademarks and other industrial property rights with respect to this game.

CHEQUERED FLAG 14 ved t rks of KONAMI industry Co. Ltd. c KONAMI 1988 All nghts ce

Page 2

Self Test (1)

When powered on, a memory test automatically starts. Normal: “OK” will be displayed, and then the game will start. Abnormal :“BAD” will be displayed and self test willrepeat.

Self Test (2)

Use a test switch on the cabinet or the SW3 of the DIP SWITCH No.3 on the PCB(turn SW3 ON and OFF while in the game mode).

1)MEMORY CHECK Memory test results are displayed after 30 seconds. 2)MAIN SELF TEST 1/0, SOUND AND COLOUR CHECK

  • Turn the brake pedal, start switch, service switch and cain switch ON and OFF.
  • Operate the shift lever to check LOW and HIGH.
  • Step on the accelerator to check for a high value of 9OH or more, and release to check for a low value of 3CH or less.
  • Turn the steering wheel fully clockwise to check for a high value of AOH or more. Turn counterclockwise to check far a low value of 60H or less. Release and make sure it shows between 7CH and 84H. The start switch should always be flashing. « Check steering wheel vibration by using shift lever. : Press the start switch to change the sound code. When the figure is between 01H and OCH, seat vibration is functional. Check the DIP switch settings. insert a coin to check the coin counter. Adjust monitor brightness so that the second colour bar from the left can faintly be seen. 3)CROSS HATCH TEST Press the test switch or turn ON and OFF DIP SW3 after gaing through the above main self test, and the >

*

*

screen shows a cross hatch pattern. Check distortion. Press test switch or turn DIP SW3 ON and OFF to return to game attract mode. ————-Deposit coin. ——Press start switch. + Drive your car about the circuit and finish the race within the given time, while avoiding crashing into other cars or side barriers..

  • When your car is damaged, that part of the car affected will flash. Make a pit stop for repairs. + This game consists of 3.stages. When you cross the finish line, you progress to the next stage and a new

car. » The number of the laps in each stage is as follows : lst stage so": 3 laps 2nd stage <r 4 laps 3rd stage --""- 3 laps And the game ends after you have won all 3 stages. « The game is over when : 1)the timer shows ‘O' before you cross the finish line. 2)your fuel runs out. 3)your car explodes. You will be scored according to the distance covered. Bonus points will be awarded according to your position at the finish line of each stage. lst place oer tees 100,000points 2nd place a Abe enna nececeereenen 50,000points 3rd place svvvrrrtttrerreeeee 20,000paints 4th place veene reer eer eeencane 10,006points Sth place Thad eee enneneenerernies 5,000points 6th place banca sara nrasenenerenses 1,000paints 7th and worse srreeerererterer ree Opoints

Page 3

Technical information

{)Required Power Capacity GNDB-Vce 5V4A or more

  • Check voltage on the edge connector of the PCB and make sure it.shows+ 5.0 volts. GND-(+12v) %* See Wiring Diagram. {2)Output R{redj}analog positive G(green analog positive B(blue )analog positive SYNC H-V complexed TTL level, negative (3)Use the volume knob on the PCB to adjust sound level. Turn clockwise for increased loudness. (4Handle with care.

Cabinet Information

Use a cabinet with a vertical monitor, a volumecontrolled steering wheel, a volume-controlled accelerator, a brake pedal, a shift lever (LOW/HIGH)and a light switch for start. It is recommended that a service switch and a test switch should also be equipped.

  • DIGITAL INPUT a. BRAKE°PEDAL-++ Brake is effective when the switch is ON. b. SHIFT LEVER--+--- OFF : LOW, ON : HIGH

2)ANALOG INPUT Use a volume with resistance value between 1kQ and 5k, directly proportional to the turning degree. The volume level should show the following figures in the test mode, _ a STEERING WHEEL VOLUME Neutral position: between 7CH and 84H Fully clockwise from neutral position {approximately 140 degrees): AOH or more Fully counterclockwise from neutral position (approx- ‘imately 140 degrees): 60H or less .”. b.ACCELELATOR VOLUME 4 When stepped on: 90H or more When released: 3CH or less

3)LIGHT SWITCH Use a switch with the light of DC 12V, consuming electricity 500mA or less. 4)STEERING VIBRATION FUNCTION This mechanism vibrates the steering wheel when the Diayer crashes into other carsor drives on the shoulder of the road.

  • Equivalent circuit and specifications

VEHATION SRGNAS,

  • Voltage between DCIN and GND DC +5V to OC +30V ;
  • Input corrent capacity for OUT 1 and OUT 2 Maximum 2A for each port
  • Vibration signal timing

ot LL a 32msec 96msec

2.Example

POWER SUPALY

6)SEAT VIBRATION FUNCTION When a cockpit type cabinet is built, the seat vibration function is available by utilizing an AMP board which must be obtained seperately, Refer to the wiring diagram.

Page 4

DIP SWITCH No.!| SETTINGS

FREEPLAY: You can play games without coins.

  • COIN SWITCH No.2 SETTINGS

OFF

“ON

DIP SWITCH No.2 SETTINGS

1. DIFFICULTY OF THE GAME\.;
67 7DIFFICULTY1]

i EASY NORMAL | __ DIFFICULT VERY DIFFICULT fo

  • SOUND IN ATTRACTIVE MODE

fe) ON. _ Wd SW1 thru SWS are not used.

DIP SWITCH No.3 SETTINGS

1, TITLE DISPLAY

_sw[2_TITLE

______ CHEQUERED FLAG CHECKERED FLAG

  • CHANGE OF MODE

© shows recommended settings. | O | OFF GAME 4

||ONTESTa
Page 5

WIRING DIAGRAM

me ‘06 COWNEDTOR

hecw3)
pot ontpySTANT LAMP
POWERersNDfeeeaw)
SUPPLYp15] ano230FE"

ee rH eee ee]

(TT+5y|

CI) +i Ct

FV2V fperwnrnennrs |+ av
neCSF) + iy59

& a CON COUNTER

i(EyFin counter:

a} a 0mm COUNTER? ‘pm

PRMet :ied

Co is

coLoueaee a
Monet OFRED™ist¥IDEO REG

GREEN — a CN) viDEO GREEN 4 a

alep18VIDEO BLUE.q5.4
SYNC-SeerVIDEO C.5YNC2ACKELESTEERING
GNOpore ¥IREO GNDSHEBRAKEveinVOLUME

RF SERVICE

snaees WOO T's saa rouever | PEDALand
|ee ootswitch f switce

NE * 6

SERVICE SWiaSTARTSUB PCRang
D, uyFEE C 850879%

a Bic Jeba8 TEST SW Cr] MAIN PCB pA) manta rssasesa ; 1. CNY SW ie ee OPTIGNAL APPLICATION FOR COCKPIT TYPE CABINET

CON? SW BODY SONIC ~— TRANSDUSER

START 5W AMP PCH PwRss one So EN}

Sry C23 | GONG jf 1) GHD

JAMIA S6PIN EOGE CONNECTOR 3/32 INCH FITCH

“NOTE: REQUIRED + 12v POWER SURGE KILLER SSODES FOR COIN AEN FOR UND COUNTER INSTALLED ON PCB ——

FIGHT SIDE SPEAKERS dGHM GW

LEFT SIDE SPEAKERS