CATHODE RAY TOMES

Namco Classics Vol 2

Namco Classic Collection Vol.2 (Namco, 1996) · Document · 6 pages · 10 sections · original scan

Page 1

namco

OPERATION MANUAL

A\ CAUTION In order to safely use this machine, be sure to carefully read this operation manual and the manual of the cabinet in which this machine to be installed before installation and operation.

This operation manual should be kept together with the machine.

DISTRIBUTED BY: ' NAMCO LIMITED 2-8-5 TAMAGAWA, OHTA-KU, TOKYO, 146, JAPAN

Page 2
  • Cautions
  • Be sure to turn off the cabinet whenever installing or removing the PC board. Otherwise you may be hurt by an electric shock.
  • Be sure to use an edge connector which is applied to the JAMMA standard. Any modifications such as cutting the edges of PC boards will cause a failure and also will be out of our guarantee for repair.
  • Never test the PC boards for conductivity with a multimeter or similar device. The PCB contains sensitive chips which could be destroyed even by the internal voltage of such a device.
  • Foreign matters or dust on the PC boards will cause a failure. Turn off the power and clean the PC boards with a brush or similar thing.
  • When transporting the PC boards, wrap them with sponges or air caps and pack them in a card board box so that they can avoid a direct impact from outside during shipment.
  • For maintenance, contact your distributor.
  • Specifications 1P, Start 2P, Start
  • Control panel: One-side 2-P specifications + 4-direction lever: 2 (IP, 2P, 1 each) + Button switch: 2 (IP, 2P, 1 each) Par + Start switch: 2 (IP, 2P, 1 each)
  • PC board size: 230 x 210 mm bad rony bas a
  • Direction of monitor: Vertical 1P, button switch] 2P, button switch 1 2P,4-direction Fig. 1
  • Connection
  • Connection of control panel See above to connect JAMMA hamess and extended hamess(accessory) to control panel through the cabinet (see P5 : PC board connector table) Connecting expanded harness to the right speaker allows you to enjoy a stereophonic effect.
  • Connection of PC board Set the PC board in the cabinet and connect JAMMA edge connector and 48P extended edge connector (DK 225D-10024C2-2312) to the PC board.

4. Explanation of PC Boards 48Pextendededge 56P edge connector

connector (GAMMA)

  • Option switches ——T1, No.1 to "ON" for Test Mode. 12 fe) No.2 to "ON" for Screen Freeze. Normally, all of the option switches are "OFF". N{ Speaker volume

(2) Speaker volumes ™%W Brightness volume

To decrease the sound volume of the speaker, turn the not use brightness speaker volume counter-clockwise. volume Fig.2

  • Test Mode
  • The PC Board enters the test mode by setting the test switch on the PC Board to “ON" on the game screen. And the test menu screen is displayed on the monitor. Use the test switch (For connection, see P5: PC Board Connector Table) on the cabinet or the option switch on the PC Board. (see P1: 4.(1) Option switches) When an item is selected by operating the 1P control lever up and down and the 1P button switch! is pushed, the selected testscreen is displayed.
  • Game fees can be changed on the coin option screen, and the game difficulty can be changed on the game option screen. Select an item by operating the 1P control lever up and down, and change its contents using the 1P button switch! (see the option setting table). After that, push the 1P Start to return to the test menu screen.

-l-

Page 3

SWITCH TEST. SOUND TEST. COIN OPTIONS GAME OPTIONS OBJECT TEST. SCROLL TEST A.D.S. COLOR TEST CONVERGENCE TSTE

(Test Menu Screen) | (a) Switch test screen

  • Sound test screen
  • Coin option screen (Setting of game fees) (& Game option screen (Setting of game difficulty)
  • Object test screen
  • Scroll test screen
  • ADS. screen
  • Color test screen (for monitor adjustment)

(@) Cross hatch pattern (for monitor adjustment)

[COIN OPTIONS}

1 GAME SELECT: GAME COST: 1 COIN 1 CREDIT DISCOUNT TO CONTINUE: NO) COIN I MECH VALUE 1 COIN COUNT AS 1 COIN COIN 2 MECH VALUE 1 COIN COUNT AS 1 COIN COIN 3 MECH VALUE 1 COIN COUNT AS 1 COIN COIN 4 MECH VALUE = 1 COIN COUNT AS 1 COIN BONUS FOR QUANTITY BUY IN: NONE USER SELECT

YES SPEAKER OUT: STEREO. COIN COUNTER: COMMON.

FREE PLAY: NO [GAME OPTIONS]

MUSIC IN ATTRACT:

ORG “PACMAN” OPTIONS ARG “PACMAN* OPTIONS} 1 ORG "RALLY-X" OPTIONS} ORG "NEW RALLY-X" OPTIONS: ARG “RALLY-X” OPTIONS + 8 ORG “DIGDUG" OPTIONS 1 ARG “DIGDUG" OPTIONS

(Coin Option Screen)

(Option Setting Table) (Game Option Screen)

( < Standard Setting) Item Contents

1. Game fees‘one count required for one game (one credit)1<[1-9]
2. DISCOUNT50% discount when continuing a playNO < YES
3. COIN 1 MECH VALUE‘Count per coin1<[1-9]
4, COIN 2 MECH VALUECount per coin1<[1-9]
  • 6. Not used One additional coin per the specified number of NONE < 2 Coins Give 1 Coin~9 Coins. y BONUSICOIN coins Give 3 Coins
  • FREE PLAY NO< YES

(9.GAME SELECT USER SELECT < [USER SELECT, PACMAN ONLY, RALLY-X ONLY, DIGDUG ONLY] 10,MUSIC IN ATTRACT YES < NO

41.SPEAKER OUT STEREO < MONO

  • COINCOUNTER COMMON ( 1Coin counter for 2slots)< EACH ONE ( 1Coin counter for each islot) 13.0RG "PACMAN" OPTIONS Push 1P button switch to enter ORG "PACMAN" OPTIONS screen—————_a 14, ARG "PACMAN" OPTIONS Push 1P button switch to enter ARG "PACMAN" OPTIONS screen 18.0RG "RALLY-X"OPTIONS Push 1P button switcht to enter ORG "RALLY-X" OPTIONS screen————c.

16.0RG "NEW RALLY-X"OPTIONS |Push 1P button switch! to enter ORG "NEW RALLY-X" OPTIONS screen

17.ARG "RALLY-X" OPTIONS [Push 1P button switch! to enter ARG "RALLY-X" OPTIONS screen

18.0RG "DIGDUG” OPTIONS Push 1P button switch1 to enter ORG "DIGDUG" OPTIONS screen—————e 19.ARG "DIGDUG" OPTIONS: Push 1P button switch! to enter ARG "DIGDUG" OPTIONS screen +

Game fees Credit” [Note

@&OHD | displaySet 3),’corresponded
Example|! 2ame_(Continueto Coin Mech 1&2 in
TOO yen[100 yen1 COIN ICREDIT[NO|ICOUNT ICOINNONE[CREDITO| (.
100 yen | SOyen|2COINSICREDIT[YES|ICOUNT 2COINS[NONE [CREDIT 0/2

©

wm TAL

Page 4

4 Original Pacman Option Screen b .Arranged Pacman Option Screen

[ORG “PACMAN” OPTIONS} IARG "PACMAN" OPTIONS] . 4 DIFFICULTY LEVEL: +?

DiEriCuL Ty LEVEL20posal

PACMAN: 25 EXTEND: 26

Sa=t3 PACMAN
PANcaeIST40000PTS

EXTEND: 23

1ST 10000 PTS

(Option Setting Table) ( < Standard Setting) Item Contents 2.0. DIFFICULTY LEVEL INORMAL < [NORMAL, HARD] 2.1. FINAL ROUND Set final round to end a game compulsorily 21 <[21,31,41,51, ENDLESS]

2.2. PACMAN J3 PACMAN <[1,2,3,4,5]

  • EXTEND 1 0000PTS < [NOBONUS, 10000PTS, 15000PTS,20000PTS] a aeons ‘ro orrTT Derr eCTTTCTTTTTEITT’=/= EEUU 24, DIFFICULTY LEVEL INORMAL < [EASY, NORMAL, HARD] 2.5. PACMAN 3 PACMAN <[2,3,4,5,6]
  • EXTEND HST 40000PTS < (NO BONUS, 1ST 40000PTS, 1ST 40000PTS 2ND 100000PTS]

¢ Original Rally-X Option Screen (New Rally-X Option Screen) d .Arranged Rally-X Option Screen

[ORG "RALLY-X" OPTIONS] [ARG "RALLY-X" OPTIONS} FINAL ROUND:——}——-2 7 DIFFICULTY LEVEL} 3 0 ROUND 15 NORMAL

MYCAR:28MYCAR:31

3CAR 3CAR

EXTEND: 29

IST 20000 PTS

(Option Setting Table) (< Standard Setting) {tem Contents

  • FINAL ROUND (Set final round to end a game compulsorily {ROUND 15 <[15,31,47,63, ENDLESS]
  • MYCAR 3 CAR <[2,3,4,5,6] HST 20000PTS <[RALLY-X:selectable from 5 pattems]
  • EXTEND [NEW RALLY-X:selectable from 7 patterns] 3.0. DIFFICULTY LEVEL INORMAL < [EASY,NORMAL, HARD] 3.1. MYCAR 3 CAR <[2,3,4,5]
Page 5

e .Original Digdu; tion Screen f .Arrange Digdug Option Screen

[ORG "DIGDUG” OPTIONS] [ARG "DIGDUG" OPTIONS}

DIFFICULTY LEVEL:————__}-3 2 DIFFICULTY LEVEL:——_}—3 6 NORMAL (ORMAL FINAL ROUND: 3 3 DIGbUG: ———_—____—_+-3 7 24 ROUND 3 DIGDUG CONTINUE: 3 4 EXTEND: 3 § DISABLE 1ST SO000PTS: DIGDUG:— +3 5, 3DIGDUG (17/82)

EXTEND: 1ST 10000 PTS

(Option Setting Table) ( < Standard Setting) Item Contents 3.2. DIFFICULTY LEVEL JNORMAL <[EASY, NORMAL, HARD, VERYHARD] 3.3. FINAL ROUND {Set final round to end a game compulsorily 24 < (24,36,48,60, ENDLESS)

3.4. CONTINUE peat <[DISABLE,ABLE OLD,ABLE NEW] B DIGDUG 1ST 10000PTS < (initial 3,add 1 at 10000 points) 3.5. DIGDUG & EXTEND selectable from 32 patterns]

3.6. DIFFICULTY LEVEL INORMAL < [(EASY,NORMAL, HARD}

3.7. DIGDUG 3 DIGDUG< [2,3,4,5]

3.8. EXTEND ST 50000PTS < [NO BONUS, 1ST 50000PTS, 1ST 50000PTS 2ND 150000PTS]

Page 6
  • PC Board Connector Table

JAMMA edge connector (56P 3.96 mm pitch) Solder side Terminal No. Parts side

GND A 1 GND

GND B 2 ‘GND

+5V¢3+5V
45VD4+5V

E 5

+12VF6+12V
linsertion errorH7Insertion error

preventing [preventing

[Coin counter 2J8[Coin counter 1
K9[Coin lockout 1
Speaker (-)L10[Speaker (+)
[Audio (GND)MTI[Audio (4
Video GREENN12|Video RED
Video SYNCPp13[Video BLUE
(Service switchR14[Video GND

s 13 _ {Test switch

Coin switch 2T16(Coin switch I
2P start switchU17[IP start swich
[2P lever UPVv18|IPlever UP
P lever DOWNW19|IP lever DOWN
2P lever LEFTx20{IP lever LEFT
RP lever RIGHTY21‘{iPlever RIGHT
2P button Switch!|Z22[IP button Switch!

a 23 b 24 G 25 d 26

GNDe27‘GND
‘GNDt28‘GND

+ Do not connect anything to the blank connectors. + Both lockout solenoid and coin counter operate on +12V. + Connect the switches to N.O. terminals such as a microswitch, and the GND to the COM terminal.

+ The supply voltage is available within +5%. For use in the best condition, get the supply voltage as close to the specified voltage as possible.

(Recommended power capacity)

+5 V 45% 2.5A or more +12V 45% 2.0A or more Extended edge connector (48P 2.54 mm pitch) Solder side "Terminal No. Parts side peaker R(-) [YEL] | Al Bi [Speaker R (+) [ORG] Az B2 3 Bs aa Ba insertion error AS BS [Insertion error [preventing key [preventing key AG BE AT BT AB BE

a BO Alo | Bio Ail_| Bit Al? | BI? Ais | BIS Ait | Bid Ais | BIS Aié | Bis aiT_| B17 Ais | BIB Aid| BIS A200 | B20 All | -B2t A22 | B22 Aaa | B23 Ax | B24

{Connection to stereo cabinet] (1)STEREO / MONO setting Select SPEAKER OUT in the game option screen at the test menu screen.

<Caution>Monophonic cabinets do output only the left-hand sound even if the stereophonic setting is selected.

  • Connection to speakers + Connect the (L) speaker to the speaker output of S6P edge connector (JAMMA) on the PC board. + Connect the (R) speaker to Speaker R (+), (-) of 48P extended edge connector.
  • Use a DDK 225D-10024C2-2312 as a 48P extended edge connector.