CATHODE RAY TOMES

PSIO Quick Start Guide (R11)

PlayStation (Sony, 1994) · Installation Guide · 2 pages · original scan

Page 1

25018 R1.1

PlayStatione Input Output

Quick Start Guide

9510-2412

Copyright 2010-2019 Cybdyn Systems® http://cybdyn-systems.com.au/

Quick Start Instructions

PlayStatione Input Output

  • Install the Switch Board

For PSIO to function, a Switch Board must be soldered onto your PlayStation® mainboard. Failure to do so will render the cartridge unusable.

  • Locate the included Switch Board Kit in this box. The kit contains the Switch Board, label and wire.
  • Install the Switch Board by soldering it onto your PlayStation® mainboard,
NOTE: The Switch Board installation guides and information about why this is required are available at: http://ps-io.com/switch_board 9510-2412

Printed in China

  • Copy the Menu System

© Format an SD Card (4 GB to 32 GB Cards should be formatted as FAT32 and anything above 32 GB must be formatted as exFAT).

  • Download the PSIO Menu System from: http://ps-io.com/downloads

© Copy and paste ‘MENU.SYS' to the root of the SD Card.

  • Add Software Images

‘Find an image that you would like to add to the SD Card,

  • Ensure itis a PlayStation® format image (BIN, ISO or IMG extensions permitted only),
  • Copy it to a folder on the SD Card, EG: 'SD.ADEMO 1\demo!.bin’ (where 'SD:V" Is the root directory).
Page 2
  • Insert the SD Card

Insert the SD Card into your PSIO Cartridge. Make sure that itis inserted in the correct. direction as seen in the diagram below.

  • Plug In and Power On

Firmly plug your PSIO Cartridge into the PlayStation® Parallel /O Port and power (on your console (as seen in the diagram below).

  • Setup the Menu System

When you power on your PlayStation® the Menu System will begin the setup process.

  • Follow the on-screen prompts to configure the Menu System,

NOTE: If you ever need to reset the Menu

‘System, hold [START] + [SELECT] whilst the PlayStation® is booting,

  • Select a Software Image

** Use the [DIRECTIONAL BUTTONS] to scroll through the list of software images and press the [CROSS] button to make a selection.

** Press the [CROSS] button again to boot the selected software image.

  • To select a new software image, press the [RESET] button on the PlayStation® console.

Basic Troubleshooting

Itis strongly recommended that your PSIO cartridge is up-to-date with the latest firmware(s). For information on how to update, please refer to the ‘Systems Manual’ here: http://ps-io.com/downloads

Ifyou have any other issues with your cartridge or if further issues persist, please report them here: http://ps-io.com/problem

Frequently Asked Questions

Q: When I select my image why do I get a message saying “No Image Found™ ‘A: Make sure that the software image filename does not exceed 60 characters and is. either a BIN, ISO or IMG file.

Q: When I plug in my PSIO Cartridge why does it not boot to the Menu System? A: Ensure that you have installed the Switch Board correctly and the ‘MENU.SYS' file has been copied to the root of the SD Card. Also check that the PlayStation® Parallel /O Port is not corroded or damaged and that the cartridge is plugged in firmly.

Q: My software images are not playing any audio. Why can’t | hear any music or background audio? ‘A: Most software images use Compact Disc Digital Audio (CDDA). To learn how to enable CDA, please refer to the ‘Systems Manual’ here: http://ps-io.com/downloads