CATHODE RAY TOMES

VS Mach Rider

Vs. Mach Rider (Endurance Course Version) (Nintendo, 1985) · Document · 2 pages · original scan

Page 1

VS. MACH RIDER * (Operation Manual) MDS(MGS)

|. How to install Software ROMs

Each Software ROM is labeled with a Location Number shown on it

r¢ RW Shaded Portion illustrated below), which indicates the

corresponding location on the P.C. Board where it should be installed.

This VS-Pek contains 6 Software ROMs and 1 Custom IC, which have

location numbers 1A or 6A. 15 or 6B, 1C or 6C, 1D or 6D, 2A or 8A,

2B or 8B, and 2F or 8F. Each ROM and IC must be mounted into the

proper IC Socket.

For VS.DUAL SYSTEM (two monitors): If this VS-Pak is to be installed

in mail (left) side of cabinet, then EPROMs and Custom IC should use

locations iA, 1B, 1C, 1D, 2A, 2B, and 2F. For sub (right) side, use

locations 6A, 6B. 6C, 6D, 8A, 8B, and 8F.

For VS.UNISYSTEM (one monitor): This VS-Pak EPROMs and Custom IC

must use locations 6A, 6B, 6C, 6D. 8A, 8B, and 8F (sub side).

NOTE: This VS-Pak can be interchanged between left and right side on

two monitor game.

@ AB C DEF HJ KLM N PR

CAUTION: Make sure the Software ROMs and Custom ICs are inserted properly.

SW1 corresponds to this program. g MAIN (Left side for two monitor game--Not usec = ©

©) for one monitor game)

Ndd-10-SOW I I

I

I

° SW° corresponds to this program. tc SUB (Right side for two monitor game--Aiso used for one monar game* GC:

  • <=
Page 2

This page reads as a drawing: its text was drawn rather than typeset, and comes out in fragments. See the original scan.