CATHODE RAY TOMES

Tempest CO-190-01 New Roms

Tempest (rev 3, Revised Hardware) (Atari, 1980) · Change Order · 1 pages · original scan

Page 1

New Program for Tempest” Game

Supplement to TM-190, Tempest Upright; TM-193, Tempest

Cocktail; and TM-196, Tempest Cabaret™ Operation, Maintenance and Service Manuals

The erasable programmable read-only memories (EPROMs) in this game contain a new program that changes the Tempest™ self-test. Refer to Figure 6, Part 2 in Tempest Upright and Cabaret Manuals, and Figure 7, Part 2 in Tempest Cocktail Manual.

To test the encoder wheel (Step 3), rotate the wheel slowly. On the lower right of the screen, a line segment rotates around one endpoint (like a hand on a clock). Slowly rotate the wheel clockwise, and the line rotates clockwise. Rotate the wheel counterclockwise, and the line rotates counterclockwise.

AUDIO 1 is BAD ROM AT AY Is “Ss \f the line does not rotate as described, the harness wires are loose or incorrectly connected, or the encoder wheel is bad.

A linear scale test has been added to Step 5. A rectangle appears at the display edges and shrinks smoothly to about 3 screen size. The rectangle snaps back to full size and shrinks again.

If the rectangle abruptly changes size, there is a probiem in the linear-scaling circuit D9 and D10 and associated circuitry.

ENTIRE WHITE FRAME VISIBLE ANO WITHIN YeINCH OF VIDEO DISPLAY EDGE

TOGGLE SWITCH &

—— policy al 112 aE —" GAME SWITCH AT N13. — SWITCH AT DIEZ nrc AT MIS fooooooa seerrow ar ves START 2 AA 1 —-— encooer \ ‘\ | WHEEL START RIGHT COIN MECH

supdisne LEFT COIN MECH

SLAM SWITCH

PHOTO ABOVE SHOWS AN EXAMPLE ONLY

Self-Test Screen