CATHODE RAY TOMES

Asteroids Deluxe DP-165-2nd-01A

Asteroids Deluxe (rev 3) (Atari, 1980) · Drawing Package · 1 pages · original scan

Page 1
Scan of page 1

INTERNATIONAL X-Y POWER SUPPLY WIRING DIAGRAM (035887-01 A)

Drawing Package Supplement

to

ASTEROIDS DELUXE™

Operation, Maintenance and Service Manual

Contents of this Drawing Package

Game Wiring Diagram, Coin Door and Power Supply Sheet 1, Side A

Microprocessor Sheet 1, Side B ‘Switch Inputs, Coin Counter, LED and Audio Outputs Sheet 2, Side B

Video Generator Sheet 2, Side A

ATARI

© 1961 Aas ne ‘Sheet 1, Side A DP-16501 2nd printing U.S. X-Y POWER SUPPLY WIRING DIAGRAM (036352-01 A) REGULATORI/AUDIO | PCB SCHEMATIC (034485-03 A) DeLuxe

‘The egulato/Autio PCB has th dal untions of egy voue {8 lating ines 8 VOC topic power to tno game PS and ama Wing the audo tom he game BCE Regulator Circuit The regulator consists of voltage regulator Qt, current ‘source power transistor Q3 and Q3's bias transistor 2. The regulator accurately regulates the logic power input to the

ditectly from the +5 VDC and ground inputs to the game PCB. Therefore, t F regulates the voltage on the ‘game PCB. This eli ‘reduced voltage due to IR. Buildup on the wire harness between the regulator and the ‘game PCB. Variable resistor PB is adjusted for the +5 VDC ‘on the game PCB. Once adjusted, the voltage at the input of the game PCB willremain constant at this voltage. ~~ Regulator Adjustment

  • Connect a voltmeter between +5 V and GND test points of the game PCB. ‘Adjust variable resistor R& on the RegulatoriAudio | PCB. for +5 VDC reading on the voltmeter.
  • Connect a voltmeter between +5 V REG and GND on the Regulator/Audio | PCB. Voltage reading must not be Greater than +53 VDC. It greater, try cleaning edge Connectors on both the game PCB and the Regula toriAudio | PCB, If cleaning PCB edge connectors doesn't decrease voltage difference, connect minus lead of voltmeter to GND test point of RegulatoriAudio | PCB and plus lead to GND test point of game PCB. Note the voltage. Now connect minus lead of voltmeter to +5 REG test point on Regulator/Audio | PCB and plus lead to +5 V test point on game PCB. From this you can see which harness circu is dropping the voltage. Troubleshoot the appropriate harness wire or harness connector.

‘Audio Circuit ‘The audio circuit contains two independent audio ampli fiers. Each amplifier consists of a TDA2002AV amplifier with again often.

BRITISH-MADE COIN DOOR SCHEMATIC (037050-01 A)