CATHODE RAY TOMES

G-80 Power Supply (Service Note 001)

G-80 Power Supply (SEGA) · Service Note · 1 pages · original scan

Page 1

SERVICE NOTE

EFFECT: 6-80 Power Supply

NUMBER: 001

It has been noted that an "in-house'' modification of the G-80 Power Supply (P/N 800-0191) may not have been accomplished on all units in the field; the result of which distributes ground current return to an additional connector pin, We recommend that you verify and/or perform the following simple procedure. A list of games which utilize this power supply is below:

  • With the rear electronics compartment door open, remove the two phillips screws securing the power supply cover and set these and the cover aside.
  • Referring to the illustration below, inspect P4 pin-4 to see if this pin has been tied to ground, either by a "'solder=bridge" or jumper-wire to pin-6 of the same plug.
  • In the advent your unit has not been modified, simply expose the ''land'! immediately adjacent to P4 pin-4, and solder a connection between the pin and the top of the PC board (P/N 800-0170); or if you prefer, simply solder a wire (14 AWG minimum) between pin-4 and pin-6 of Pk, This completes the modification.

G-80 Power Supply PC Assembly 800-0776 T™ ASTRO BLASTER ng GLa ae x i" space opyssey"™ om 5 got = space Fury’ “Sdn je a se 2 Ss. ELIMINATOR >, or a oos™

a zextor™! S00 [I f) Tac/scan™" we MONSTER BASH!" penco™

SEGA Electronics, Inc., 16250 Technology Drive, San Diego, CA. 92127-1985 toll-free technical assistance: inside CA 1-800-722-8576