CATHODE RAY TOMES

Plinker's Canyon Bulletin Nov-17-1977

Plinker's Canyon (Sega, 1977) · Service Bulletin · 2 pages · original scan

Page 1

Jo: All Distributors From: Customer Service

November 17, 1977

Subject: Replacement of Copy: caser diode in Plinker's Canyon Rifle

Please find enclosed a replacement for page 15 of

the Plinker's Canyon Operation and Service Infor-

mation Manual. Please note the caution at the

bottom of the page. This is a requirement by the

Federal Government.

Page 2

SEGA

REPLACEMENT OF LASER DIODE

Follow procedure to remove laser driver board and unfasten the two #6 tap- Ping screws from the side plates. Pull barrel from gun assembly and using a 7116 inch dowel press lightly against diode lens holder through the front end of the barrel. Carefully remove diode assembly from barrel. Unsolder connecting leads and unscrew diode from holder to replace. Damage to laser diode can result if excessive heat is applied when soldering. For correct shooting pattern place diode with the inner flat side towards the bottom of the barrel, Align diode holder assembly with the off center diode towards the top of the barrel as view from the rear.

See illustration below.

Top of Barrel

Laser Diode

Laser Holder

Rear View

Flat Top of Holder.

Laser Holder

Laser Diode:

Flat Side of Diode Front View

CAUTION: Use of controls or adjustments or performance of procedures other than those specified herein, may result in hazardous radiation exposure,