CATHODE RAY TOMES

Ridge Racer 2 Update 1

Ridge Racer 2 Update 1 · Document · 1 pages · original scan

Page 1

TECHNICAL BULLETIN

RIDGE RACER 2 ACCELERATOR/BRAKE ASSY

Problem:-Not accelerating properly and/or brake remaining partly on.

Cause:- Quadrant Gear moving on the shaft.

Remedy:- Drill a 3mm hole through the quadrant gear and shaft and fit an M3x15 screw and nut.

INSTRUCTIONS

DISCONNECT FROM POWER SUPPLY BEFORE COMMENCING

  • Remove four hex head bolts (M6x20) and withdraw the pedal assembly forward from the machine.
  • Disconnect the connector.
  • Loosen the quadrant gear clamp screw and remove the quadrant gear.
  • Turn the potentiometer shaft almost fully clockwise and refit the quadrant gear (see diagram below for correct position) ensuring that the clamp screw is fully tightened.
  • _ Drilla 3mm diameter hole through both the quadrant gear and shaft and fit an M3x15 screw and nut as shown.
  • Connect the connector and refit the pedal assembly to the machine.
  • Re-initialize the game (see operators manual) before the game is played.