Crisis Zone Deluxe Updates 1 & 2
Crisis Zone (World, CSZO4 Ver. B) (Namco, 1999) · Document · 4 pages · 3 sections · original scan
CRISIS ZONE DX - MODIFICATION
Before commencing this modification, ensure that the game is switched OFF and disconnected from the power supply
1 Remove 6 off security screw (M5x15), undo the lock and remove the Joint Box Cover.
Security screw 0sx18) Security screw ‘wexts) ont Box cover FF
Monitor Cabinet
Joint Bax
2 Fit the new bridge rectifier as shown below using 1off wood screws No6 x 34”.
- Remove the fuse and the fuse holder cover.
4 Disconnect the grey wire, going to the gun, from the fuse holder.
5 Connect the wire, with the flat blade, from the rectifier to the grey wire previously removed from the fuse holder.
5 Connect the other wire from the rectifier to the fuse holder. Fuse
- Refit the fuse holder cover and fuse. | —— Fuse Cover
; , Rectifier Assy
- Refit the Joint Box Cover.
Wood Screw J (No6 x %")
CRISIS ZONE
To extend the life of the Gun Motor, it has become neccesary to reduce the voltage to the motor from 24v DC (as shown on the schematic), to 22v DC.
This has been accomplished by the addition of 1 or 2 bridge rectifiers placed in the circuit between the 24v DC 3A Fuse and the Gun PCB.
Transformer Part No 67700015
BLUE ov. | BROWN 3 O\_- ay, 1AQB GRNIYEL ov
18V
>—1lH— 22,000uf 35v 24v DC 22vDC > TO GUN PCB ONL a
7 N
- Wea
Additional Bridge Rectifier/s to reduce 24v to 22v DC
From Fuse
Bridge Rectifier Part No. 71000040
From Fuse
This page carries no recoverable text. It is a drawing or a photograph. See the original scan.
IMPORTANT
Two model types of Toshiba Projection Monitor are used on the CRISIS ZONE DX.
The only visible difference is the Video Input Connection.
Model P503SG1 uses BNC connectors and Model P503SG2_ uses a 15way mini ‘D’ Connector.
All Crisis Zone DX games have BNC connectors fitted to the Video Loom coming from the Joint Box.
When model P503SG2 is used, a “Toshiba BNC to D Adaptor be fitted. (This adaptor loom should remain with the projection time for repair or exchange).
WINNER ac IN R GB GSYNC
IMPEDANCE INPUT LEVEL; a q
P503SG1 IMPEDANCE INPUT LEVEL; aw
P503SG2 Loom”, (Part No 69200080), must monitor if it is returned at any