CATHODE RAY TOMES

Armored Car

Armored Car (set 1) (Stern Electronics, 1981) · Document · 10 pages · 13 sections · original scan

Page 1

ARMORED

CAR

i,’ ELECTRONICS, INC. +3 "3 725 Di Parkway, Chi pHi 60614 theit BH CH oa 935-4600, Telex 25-4657 sl Toll Free Service Assistance (800) 621-6424 12G-10-167-M

Page 2

The object of the game is to pick up as many monies as

and bring them to the bank.

Monies are placed randomly along the streets; avoid Robbers'

cars while trying to pick up monies. Robbers' cars also pick up

monies as they drive along the street; they also are trying to

keep you from the Bank. The direction of the Bank is indicated

by arrows on the screen, and your distance from the Bank is

shown on your indicator at the bottom of the screen.

Your fuel level is shown on the Fuel Meter which is also at

the bottom of the screen. Between each Bank there are two fuel

stations, and driving through them refills your fuel tank.

Intersections with arrows are one-way intersections; you can

go only in the direction the arrows point, up and down or left

and right. The direction of the arrows change every few seconds.

Before each change you will hear a tone which will let you know

that a change in arrow direction is coming.

Bach player starts with four Sawhorses. Use the Sawhorses

to stop the Robbers' cars or to go through an intersection

whose arrow is blocking your path. An extra Sawhorse is

awarded for every four monies brought to the Bank. Sawhorses

will only stop the Robbers’ cars, and stopping a Robbers’ car

awards 200 points. Sawhorses will not stop the Street Sweepers,

Steam Roller, Ambulance, or T.N.T. Truck. Sawhorses can only

be dropped at an intersection.

Page 3

Using second gear enables you to speed up and avoid Robbers’

cars or to pick up monies fasters, because you're going twice

as fast. Using second gear also causes your fuel to go down

twice as fast.

In each rack there is a Key and a Lock, and picking up the

Key and bringing it to the Lock awards 1,000 points.

The Steam Roller appears in the second rack and changes

Arrows to Sawhorses. Steam Roller continues through all racks.

The Ambulance appears in the third rack and continues through

the rest of the racks. It moves in a straight line and travels

as fast as your car in second gear.

The T.N.T. Truck appears in the fourth rack and continues

through the rest of the racks. It moves in a straight line

from right to left, unless it sees your car at an intersection.

If it does see your car, it will turn in your direction and

continue in a straight line until it sees you again or crashes

into a wall.

The Street Sweeper will sweep up Sawhorses and Arrows.

An extra Armored Car is awarded at the fourth and the

eighth bank.

Page 4

1.1

1.2

1.3 SECTION 1 INSTALLATION

INTRODUCTION

This game has been STERN final tested and is ready to play, but on all games there are some items that must be checked after shipment. Making these visua! inspections may avoid time consuming service work later. Minor troubles caused by abusive handling in shipment are unavoidable, such as cable connectors that may have become loosened. Check ALL CONNECTORS on the game to make sure they are firmly seated. Check to make sure that the game control boards are firmly seated. Examine the exterior of the game cabinet for dents, chips or broken parts. Check all major sub-assemblies, control panels, and T.V. monitor to make sure that they have not loosened up during shipment.

VISUAL INSPECTION BEFORE PLUGGING IN LINE CORD

  • Check the transformer for any foreign material shorting across wiring lugs.
  • Check that fuses are firmly seated and making good contact. Line fuse (3 AMP SLO-BLO) located on the transformer board, fluorescent lite fuse (1 AMP SLO-BLO) located on the fluorescent board, and 3 circuit board fuses - located on the power supply board (See drawing B).
  • Check the T.V. for any foreign material that could cause shorts (VISUAL INSPECTION ONLY).
  • Check game boards for any foreign material that could cause shorts. Make sure ribbon cables are pushed into circuit boards.

ON/OFF POWER INTERLOCK SWITCHES

  • The on/off power switch is located on the top right side, 12 inches from the front.
  • There are two interlock main power switches by the front door and one by the back access panel.
  • Interlock switch interrupts all power from game except service outlet. Interlock switch can be locked in “on” position by pulling stem out when servicing game.
Page 5

GENERAL INFORMATION

6. Wiring for a counter is inside the front door on the left hand side of cabinet. (6 VDC COUNTER).

There are two coin chutes on the front door that are connected in parallel. (Note: They cannot be adjusted to work separately, SEE DIP SWITCH SETTINGS BELOW .

Game adjustment switches are located on CPU board. (See below for adjustments).

The electronics package used in ARMORED CAR is the same for stand-up model and cocktail table model. {They can be interchanged if Dip Switch #5 is changed on CPU board).

Volume control for electronic sound is located on CPU board.

Power supply board has an adjustment (See DWG B) for the +5 VDC regulator, this MUST BE SET BETWEEN +5.0 VDC and 5.25 VDC.

SERVICE INFORMATION On power-up the Program Chips are checked, the location of a bad chip will be displayed on the screen. For the Switch Test hold the player two button during power-up.

GAME ADJUSTMENTS

SWITCH

ATTRACT MODE SOUND YES ON NO OFF

SWITCH CARS 2 3 ON 8 OFF

COIN SWITCH 3 4

4COIN1PLAYOFFOFF
SCOIN1PLAYOFF ON
1COINIPLAY‘ONOFF
2COINPLAYONON

SWITCH

UPRIGHT ON

TABLE OFF

Page 6

ay

+5V TRANSISTOR

MOUNTED ON

BACK OF BOARD

DEMO-SOUND {1

cars (2

COINS 8

RIBBON CABLE

CPU BOARD

HEAT sinc [TIT TURN CLOCKWISE

(4 CABINET MODEL (5 Not useD (6 Q00000)° IN

CI VOLUME CONTROL

AS+ tal OND tal AgL+ tii AS td +12u -5V GND +5V +5V KEY GND GND GND ING GIMos it asnray a FF

Ps-1200 + + F2 4aMP_2AMP 1 AMP

ASSY REV cr il Ct F3 cR1 DIODE BRIDGE AC GND GND Ac GND GND KEY GND

BaWBOSSNVEL OU PROGRAM E-PROMS

Page 7

ARMORED CAR

12A-253-167 PACKING LIST

4A-173 PLASTIC BAG 8A-111-1 1 AMP FUSE BA-111-2 2 AMP FUSE 12D-339-S MONITOR SCHEMATIC 12G-10-167-M MANUAL 12G-10-167-S SCHEMATIC 12A-281 RETURN CARD 34C-978-S PS-1200 SCHEMATIC 13C-2-32 QUARTER WINDOW

Page 8

WARNING: THIS EQUIPMENT GENERATES, USES, AND

CAN RADIATE RADIO FREQUENCY ENERGY AND IF NOT

INSTALLED AND USED IN ACCORDANCE WITH THE INSTRUCTION MANUAL, MAY CAUSE INTERFERENCE TO RADIO COMMUNICATIONS. AS TEMPORARILY PERMITTED BY REGULATION IT HAS NOT BEEN TESTED FOR COMPLIANCE WITH THE LIMITS FOR CLASS A COMPUTING DEVICES PURSUANT TO SUBPARTJ OF PART 15 OF FCC RULES, WHICH ARE DESIGNED TO PROVIDE REASONABLE PROTECTION AGAINST SUCH INTERFERENCE. OPERATION OF THIS EQUIPMENT IN A RESIDENTIAL AREA IS LIKELY TO CAUSE INTERFERENCE IN WHICH CASE THE USER AT HIS OWN EXPENSE WILL

BE REQUIRED TO TAKE WHATEVER MEASURES MAY BE

REQUIRED TO CORRECT THE INTERFERENCE.

Stern Electronics, Inc. 1725 Diversey Parkway, Chicago, !llinois 60614, 312/935-4600, Telex 25-4657

124-290

Page 9

[T

1x301,%302,x300,x308 ‘SYNC AMP. ' 1g BSC48AC or eBci68s

weet var [[xs03 oes umiter 254673 Pi [304 BLANKING

  • | 28casac or acices x304 ——

X90! POWER DRIVE 2502688 X 902 ERROR AMP —25( 1890

Boros asciasa R REGULATOR

dF lie Ya ear tf)

Lal Beceen se Bes6ben 250869 or

AcIZ0V 6OHz/SOHE 10%

Page 10

X103 ond xI08 VIDEO AMR, 2scasac XI04 ond _Xi06 VIDEO AMP 254673 ‘x03 C: TRGB Per 28cisiav VIDEO OUTPUT | 12B-339

i

i neerenn yor DEFLECTION YOKE

00-4147-04 G07-CBO Schematic Notes Unless otherwise specified Resistance: (Q) (K->KQ, M-~MQ), 1/4 (W) carbon resistor Capacitance: 1 or higher-» (pF), less than 1+ (yF) working voltage -» 50 (V) ceramic capacitor Inductance: ( H) Electrolytic Cap: Capacitance Value (/F)/working voltage (V), NP — non-polar (or bipolar) electrolytic cap. Refer to the parts list for additional component information.

  • indicates test point connection hy indicates chassis ground unless otherwise specified Hz indicates cycles per second For safety purposes (and continuing reliability) Aa replace all components marked with safety syrnbol with identical type.
NOTE: FR - fusible resistor —e23-

Parts identification on circuit boards: e.g. SU1126A (R107 = R1107) SU3030A (R113 = R3113)