CATHODE RAY TOMES

Guerrilla War

Guerrilla War (US) (SNK, 1987) · Document · 12 pages · 7 sections · original scan

Page 1

SAIK CORPORATION

Page 2

GUERRILLA WAR

TABLE OF CONTENTS

I. GENERAL INFORMATION

INTRODUCTION & WARNINGS GAME PLAY / INSTRUCTIONS

II. OPERATION

INSTALLATION & ELECTRICAL REQUIREMENTS

PCB SPECIFICATIONS

ROUTINE MAINTENANCE & SERVICE

OPTIONAL SETTINGS

DIAGNOSTICS

III. GAME DRAWINGS AND WIRING DIAGRAMS

PCB LAYOUT

JOYSTICK ASSEMBLY DIAGRAM

WIRE CONNECTOR LIST

CONTROL DIAGRAM FIGURE 1

FIGURE 2

FIGURE 3

FIGURE 4 oo of -F

Page 3

I. GENERAL INFORMATION

INTRODUCTION

Guerilla War is a microprocessor based coin-operated electronic game that makes extensive use of digital integrated circuitry and television monitor concepts. This manual is designed for the use of maintenance technicians who possess a general knowledge af solid-state circuitry and video monitor theory. Any individual NOT knowledgeable in these areas SHOULD NOT attempt repair of the electronic portions of the game.

In addition to this manual and training in electronics, troubleshooting and repair wil] be facilitated by access to general-type handtools, a multimeter, a 50 or 100MHZ oscilloscope and a logic probe would be helpful.

WARNING

Do not attempt to troubleshoot or repair the PCB if it is found to be faulty or your warranty may be voided and repair charges will] be more costly. Always contact an authorized SNK distributor or the SNK Service Manager to troublesheot your PCB problems.

Whenever you change parts or insert/dtsconnect the edge connector, always check to make sure the power is off! After you are sure the power 75 off, wait approximately 10 seconds before proceeding to remove the edge connector to allow time for the power supply to discharge.

Always use caution to stay clear of the high voltage sections to avoid the possiblity of electrical shock.

Page 4

HOW TO PLAY

Guerrilla War is a 1 or 2 player survival shooting game. Play can be simultaneous or either player can join in at any stage during play.

The rotary joystick controls the hero's movement and 8-way fire direc-

tion. Press yellow button to fire machine gun and press black button

to fire grenades and to get in and out of tank. Players may get into enemie's tank wher they. are destroyed. When certain enemies are killed

they change into bonus weapons. The dip switch adjusts the level of

difficulty in four stages.

ROTATE JOYSTICK FOR DIRECTION OF FIRE.

s i 1 S&S S 0s s i <2 ENADE & owe: | FIRE FIRE

QQ] &Q> LOCOe FIRE GRENADE GRENADE FIRE

Page 5

aan I]. OPERATION

INSTALLATION

Your game was shipped from the factory in ready-to-play condition. %°= is

A brief inspection is suggested before the PCB is removed from the | _ carton. If there is damage to the shipping carton, contact the freight carrier for claim purposes. After the carton has been satisfactorily inspected, remove the PCB from the shipping carton. gt AB

Examine the interior of the game for disconnected wires, cables or © 3. harnesses. Make sure the electronic devices are securely mounted in ‘” their sockets, etc. Record any problem and contact your customer service representative for technical assistance.

PCB SPECIFICATIONS

Operating requirements

Voltage +5.00 volts to 5.10 volts O.€., -5¥DC, +12V0C. Amperage 7.5 amps Power 38.5 watts Temperature 0° to 30°C or 32° to L00°F Humidity 95% relative

The 5 volt supply draws about 7.5 amps on this PCB design and the power = |. supply should be adjusted for maximum efficiency and reliability. When ~ the voltage is correct, both LEDs wil) be lit. If only one LED is Tit the 5 volt supply must be adjusted. ‘y

This machine should onty be adjusted by a QUALIFIED technician.

Page 6

OPTIONAL SETTINGS

DIP SW NO.1

("ew | srecincaion [+] 2T@]«]* le] 71°] ‘ores COIN UP CONTINUE : GAME STYLE 7 STANDARD | ON | NOAMAL PICTURE | ee DISPLAY a= osu a — (jon —_* [SECOND BONUS | Corr] Fon

1 COIN 1 PLAY 2 COIN 1 PLAY a [zcomipiay | 3 COIN 1 PLAY . 4 COIN 1 PLAY - 1 COIN 6 PLAY t COIN 4 PLAY COIN 2 JF COING PLAY 1 COIN 3 PLAY 1 COIN 2 PLAY

*Second Bonus ..... Credit one {HERO} every 2nd bonus

**Every Bonus ..... Credit one (HERO) at 1st and 2nd bonus only. No further heros awarded.

=

DIPSWNO.2

teveror [NommaL__—_——~—S—~iow fore even 2

DIFFICULTY[HARD~—sorFiOND)LeveL 3

PbiericuLT CC ONTON] LEVEL 4 ATTRACTION OFF. SOUND MONITOR CONTIAUGUS PLAY SETTING STOP VIGEG DISPLAY BONUS 0.000/50 000 POINTS 40 000/80 ,000

SETTING50,000/100,000-

|NOBONUS 1ST/2ND NO 8ONUS

NOTE: Bold face suggests factory recommended settings. ©
Page 7

DISPLAY TEST MODE

A. SELF ROM CHECK

' The memories are automatically self checked whenever power is applied. To enter the test mode, hold the test switch on until PICTURE is displayed. Press the test switch to continue the display tests or reapply power to start the game.

B. PICTURE 1 - CROSS HATCH

Adjust tha monitor for a SQUARE PATTERN throughout the display and on the edge of the monitor.

C. PICTURE 2- COLOR TEST

Assures that the correct colors are 2 COLOR TEST properly wired to the monitor. LILICI RED GREEN BLUE

D. PICTURE 3 - CONTROL TEST 3 LEVER SWITCH

Pl START 0 P2 START Pt UP P2 UP _As a lever or switch turns on, 0 on the monitor will change to 1. Turning the

joystick dial clockwise incrementsPI DOWNF2 GOWN
the LEVER DIAL by one. Turning thePt LEFTP2 LEFT
Joystick dial counter-clockwiseP1 RIGHTP2 RIGHT
decrements the LEVER DIAL by one.P1 DIALP2 DIAL

Insert coln and confirm thatthe COIN Pt PUSHI change from a 0 to 1. The service switch can also be checked here. P1 PUSH2 COIN. SERVICE P2 PUSH1 P2 PUSH2 ec eoecoeo eo 8 oO

Page 8

E. PICTURE 4 - MODE CHECK «

Set desired mode by setting the DIP SWITCHES on the PCB. {Refer to the OPTIONAL SETTINGS.) When theswitch , turns on, the number of that BIT will change from Oto 1. The actual mode will also be displayed.

F. PICTURE 5 - 7 FONT TEST

Confirm that the Characters are displayed on the moniter. There are diftarent colors of characters that will be displayad automatically. Picture 6 Font 2 Picture 7 Background Check

G. PICTURE 8 - SOUND CHECK

Set up the sound Code ("?") to 41-7F,61- - BF or CO-FF by moving the Joystick. The music, special effects or volce will actlvate when you press 1st Player Control Button A. lf you want to stop fhe sound, set the Code to OE and press 1st Player Control Button A. 4 MODE

DIP 12345678 DIP 12345678 I 0010000G 2 10101000 CONT ENUE DISPLAY NORMAL HERO 3 I COIN] IPLAY 1 COIN2 6PLAY LEVEL - 2 DEMO SOUND ON 1ST 80NUS 40,000P 2ND BONUS 80,000P EVERY

§& FONT 1

i: FONT CHARACTER eee eee ee eee

8 SOUND CHECK

SOUND CODE =?

MUSIC 41-7F EFFECT 81-BF VOICE CO-FF STOP O€

Page 9

D. JOYSTICK ROTARY CONNECT IONS:

*NOTE: “R" {Rotary} for proper connection of the harness.

Pl,

P2 a D @) Nike rs | 2H Volume Control fl e

Proper Voltage Indicating LiDe

o ATGOQ3 UP02—-—1

Page 10

E. LS30 - 24 JOYSTICK ASSEMBLY DIAGRAM +

> HOW TO REMOVE KNOB OF JOYSTICK ASSEMBLY, _—F# 1. Insert “fingers” of joystick tool under knob Make sure to align fingers with (SS) dots under knob. Push up to open top j | cap. © 2. Use hex wrench to remdve shaft nul.

PARTS NAME

LS30- tKnobeos

A Cap Wed B Knut (M8) a Soe c Knob (Main Body} D Fastener

LS30-2Lever mask:ae:
LS30-3Main guideBPs Vet
LS30- 4Micro Switch PlateaeS |
LS30-5Micra Switch.“Se
L$30- 8$0 C-ClipMeue
LS30-7Specer (6}w-.fh
LS30- 8Spacer (A}roee: 4
1S30- 8Washer {emall)~~epee
LSX-10Shatt Holder |weeens onSpay
LS30-t1=Shafi Holder Stand © -xeer7*":
LS30-32Washer {larpe)baie ~romvnen tale
LS30-13ing“eens“Er
LS30-14120 C-Cipoh!

LS$30-15 Shafi LS30-16 Star Washer LS30-17 Rotary Switch Installation Plate (SUS) LS30-18 Rotary Switch LS30-18H Harnens L§30-18 Aotary Swlich Stopper L$30-20 Stand LS30-21 Steel Base LS$30-22 Knob setting tool FIGURE ? L1SN-24 —— Assembly

Page 11

MAIN HARNESS CONNECTIONS

CONNECTOR CR7E - 56DA - 3.96 E (HIROSE)

  • . (28}

(A) (f)

{2 3 | | 4 | 5 | | 8 a

L § 10 | i | Mf 11 | Audio (+) y, f Video Green pet wise — h | P13] Video Blue PAP 4 | VideoGround | BLACK po te] Coin switchs | ya ee } 2p Stert [U7] iP Stet lal

oo F| 2P Control § PUSH 134° 2 ff 22 | 1P Control 5 PUSH 13 ee es POC Ol Po rr—“—isiSC eet p__BLack | Ground Lo p27] Ground | BLACK | Ground 28] Ground

Page 12

snl eS ae > 2. a=” L

a E. WVYSVIC ONIYIM JOYULNOD

7 ine 3 i mi BI PU tH tH inl io Hue a ‘lela abeipininialsian aalel pAnnnS RAR ts mi a" =Frrr 5 me ain - ee E : sy | Fe pte ~ i ar o

amie 6 uaavaa7™ af buwanae a iE R ERAT

et