CATHODE RAY TOMES

Battlezone DP-156-1st-01A

Battlezone (rev 2) (Atari, 1980) · Drawing Package · 1 pages · original scan

Page 1
Scan of page 1

INTERNATIONAL POWER SUPPLY SCHEMATIC (035887-01) A COIN DOOR SCHEMATIC (034988-01) A Regulator/Audio II PCB Schematic (035435-02 B)

oa CA "eras tex[SeTose set] uvlse yess set

Sas bh saect toot 6 on

a es

ssn ren ar BATTLEZONE WIRING DIAGRAM (036242-01) B

A,

ATARI

‘The Regulator/Audio PCB has the dual functions of regulating the +5 VDC logic power to the game POB and amplifying the audio from the game PCB.

Regulator Circuit

‘The regulator consists of voltage regulator 1, current

‘source power transistor Q3 and 3's bias transistof G2. The

regulator accurately regulates the logic power input to the {game PCB by monitoring the voltage through high iminputs +SENSE and ~SENSE. The inputs are itectly from the +5 VDC and ground inputs to the game PCB. Therefore, the regulator regulates the voltage on the

‘game eliminates a reduced voltage due to IR

buildup on the between the regulator and the

‘game PCB. Var B is adjusted for the +5 VOC

‘on the game PCB. Once adjusted, the voltage atthe input of

‘the game PCB will remain constant at this voltage.

Drawing Package Supplement

Regulator Adjustment

  • Connect a voltmeter between +5 V and GND test points Of the game PCB.
  • Adjust variable resistor RB on the Regulator/Audio PCB for +5 VDC reading on the voltmeter.
  • Connect a voltmeter between +5 V REG and GND on the Regulatov/Audio PCB. Voltage reading shall not be Greater than +55 VDC. If greater, try cleaning edge Connectors on both the game PCB and the RogulatorfAudio PCB. If cleaning PCB edge connectors doesn't decrease voltage difference, connect minus lead of voltmeter to GND test point of Regulator/Audio PCB and plus lead to GND test point of game PCB. Note the voltage. Now Connect minus lead of voltmeter to +5 REG test point ‘on Regulator/Audio PCB and plus lead to +5 V test point on game PCB. From this you can see which hamess circult is dropping the voltage. Troubleshoot the appropriate harness wire or harness connector. to

BATTLEZONE™

* Rea/avoie mt senem os54as-o8

Operation, Maintenance, and Service Manual

‘Audio Circuit

The audio circuit contains two independent audio amplifiers. Each consists of a TDAZ002AV amplifier with a Contents of this Drawing Package gain of ton.

Game Coin Door and Power Supply Wiring Diagrams Sheet 1, Side A . Math Box Signature Analysis Procedures Sheet 1, Side B sreacene Microprocessor ‘Sheet 2, Side A Coin Door inputs and Analog Vector-Generator Outputs Sheet 2, Side B ae a Vector-Generator Sheet 3, Side A Auxiliary PCB Math Box, Switch Inputs and Audio Outputs Sheet 3, Side B

Orme crests Sheet 1, Sido A ee ee er | DP-156-01 st printing