CATHODE RAY TOMES

Radical Radial

Radical Radial (US) (Logitec Corp. (Nichibutsu USA license), 1982) · Document · 9 pages · 9 sections · original scan

Page 1

CONVERSION KIT

INSTRUCTION MANUAL

Nichibutsu U.S.A. Corp. wey,

Page 2

RADICAL RADIAL

| 1 BLICENSE SEAL

2 |

| 4 The license seal can be displayed on the game machine as FIGURE 1. PLACE LISENCE SEAL The license seal must be visible. Use caution so that the seal may mene

not be peeled away thus losing the identity of the P.C. Board. Nichibutsu issues only one license seal for each board sold and no duplicates will ever be made. Put the seal on the back of the little window provide on our marquee or on the back of any clear glass or plastic overlay that you might be using.

FIGURE 1

POWER REQUIREMENTS

The P.C. Board requires a power supply of + 5V 3A (+5%) for game logics, +12 V 1A (410%) for audio IC only.

CONTROL PANEL SECTION

A 8-way joystick and a shoot button are required. RADICAL RADIAL will not work properly with a 4-way joystick.

COIN SELECTOR WIRING

A coin selector switch may be connected to either pin 13 (coin 1) or pin 14 (coin 2).

|_______» pin #31

Page 3

| > fa CONNECTOR PL

  • Cut the connector-plug as needed, so that it can plug into your game machine connector.
  • Insert the connector-plug into your own game connector. Use a pencil and mark ’"R”, “L’’, +5’, etc. according to signal at the pin on the connector.
  • Connect the connector-plug and 36-pin edge connector of RADICAL RADIA with wires. (FIGURE 2). Pin Marked “L” will be connected to pin #11 of RADICAL RADIAL connector. Pin Marked “R” will be connected to pin #12 of RADICAL RADIAL connector etc. (See wiring diagram)

36 PIN CONNECTOR

RADICAL c= RADIAL PCB

UPPER PCB LOWER PCB COLOR SIGNAL CABLE 6 PIN COLOR SIGNAL CONNECTOR FIGURE 2

WARNING:

Wiring of the harness that supplies the power (+5V, +12V) to the P.C. Board must be connected as specified or damage may occur. Before inserting a RADICAL RADIAL P.C.B. into the connector, check the voltage of these pins carefully.

Pin # 1, 2, 33, 34, 35, 36 = GND (OV) Pin # 5, 6, 29, 30, 31,32 =+5V Pin # 28 =+12V

Page 4

RADICAL RADIAL

|6 BTV MONIT

A color singal cable is provided to connect R.G.B. and SYNC singals from 6-pin connector located at right corner of the lower P.C. Board to the harness or to the TV Monitor directly.

Pin No. Signal RED

BLUE

GREEN SYNC

GND

N.C. PA PWNn =

TV monitor has to be equipped with TTL input level. TV monitor must be placed vertical. RADICAL RADIAL P.C. Board is designed to be used with ‘““1-SYNC” signal monitor. However, if your TV monitor has a “'2-SYNC” signal connect as dotted line in FIGURE 3.

Pin #4= V SYNC Pin #6 = H SYNC V SYNC 13

A. Instruction

B. License Seal

C. Marquee D. “How to play” card E. 2-Bracket

F. Color Signal Cable G.36-pin Connector H.Connector Plug

  • Printed Circuit Board 74LS86

er SC FIGURE 3

| (THE KITS INCLUDE

pe

pe

pe

pes

pes

pe

pe

pe

pe

Page 5

| 8 I THE SCREEN DISPALY UPSIDE

Four wires are attached to the monitor deflection yoke. Two for the horizontal control, and other two for the vertical control. When the picture is upside down, disconnect the two horizontal wires and swap the connection. When the picture is backwards, disconnect the two vertical wires and swap the connection. See figure 5a and 5b.

picture tube

: Horizontal Coil

3 7 A 4 Vertical Coil

FIGURE 5a deflection yoke coil Picture tube

deflection yoke coil

3 Horizontal Coil

3 o F 4 Vertical Coit

FIGURE 5b

Page 6

SPEAKER [ 2, em) Ako

2PIUMP 2psHoot (>

waump GD AP SHOOT [22> Service DH 2P- RIGHT ED 2P-LEFT A al P-BowN TD 2P- Bows arts ae 2puP Dt 2P START C4 PP START CD} con2 G4

1P-LEFT 1P-poun (D> 1P-uP

I

ys ELEELL EY i

Fy aw a = : pam od abn r =

se

aL aan ann Lem a ae rare " SS Se a oo ES = 4 “a > Gia am ae

aa

“chia _|

Page 7

This page carries no recoverable text. It is a drawing or a photograph. See the original scan.

Page 8

This page reads as a drawing: its text was drawn rather than typeset, and comes out in fragments. See the original scan.

Page 9

Nichibutsu U.S.A. Corp. 15407 S. Broadway, Gardena, Calif. 90248 Telephone (213) 538-2162 TWX 910-346-6952 NCBTUSA

Printed in Japan