Area 51 CO-405-01 1st Printing Troubleshooting Guns
Area 51 (R3000) (Atari Games, 1996) · Troubleshooting · 2 pages · original scan
TIME WARNER CINTERACTIVE | CO-405-01 1st printing
Troubleshooting Guns Installed with Kits
Supplement to the Area 51 Universal Kit Installation Instructions (TM-4085, 1st printing)
gy: HIS SUPPLEMENT sheet describes how to , troubleshoot the guns included with this uni- MA versal kit. If you are having problems with the guns tracking across the whole screen, check these items before calling Customer Service.
@ Check the brightness and contrast. Adjust the picture as bright and with as much conwast as you can. (However, do not boost the brightness to the point where the screen is washed out and you can see the diagonal retrace lines.)
®@ Check that you have a pure white screen in the monitor purity test (under Monitor Tests in the selftest procedure). Follow the instructions on page 2-7
Copyright © 1996 by Atari Games Corporation. All Rights Reserved. 4/96 of the Area 51 Universal Kit Installation Instructions.
@ Make sure the monitor screen is clean and free of dust.
When the monitor is properly adjusted, the guns should track to within two inches of the left side of the screen and all the wayto the right side. If you still have problems after checking these three items, call Customer Service at the number on the back of this sheet. We suggest you keep this supplement with your ATA R |
GAMES kit manual, and refer to it when installing the guns.
SUPPLEMENT “ AREA 51 GUN TROUBLESHOOTING
If you need technical assistance, call your distributor or Time Warner Interactive Customer Service at one of the following locations: United States: (408) 434-3950
Time Warner Interactive’ Atari Games Corporation,
737 Sycamore Drive Milpitas, CA 95035 (Monday-Friday, 7:30 a.m.— 4:00 p.m. Pacific time)
OR
Europe: 062-52155 Atari Games Ireland Limited, Tipperary Town, Ireland (Monday-Friday, 9:00 a.m.—5:30 GMT)