The Main Event to Crime Fighters Conversion Kit
The Main Event to Crime Fighters Conversion (Konami, 1989) · Kit Manual · 14 pages · 9 sections · original scan
KONAMI"
CONVERSION KIT INSTRUCTION MANUAL
Me Konan’ is a trademark of Konami Industry Co., Ltd. MAIN EVENT™ is a registered trademark of Konami, inc. ©1988 Konami, inc. CRIME FIGHTERS is a registered trademark of Konami, Inc. ©1989 Konami Inc. Part Number 821402
KIT CONTENTS
Quantity Part # Description 1 821003 Crime Fighter PCB 821102 Crime Fighter Control Panel Overlay 821300 Upper Right Side Decal 821301 Lower Right Side Decal 821302 Upper Left Side Decal 821303 Lower Left Side Decal 821200 Crime Fighter Marquee 821101 Crime Fighter Player Instruction 1 set 821012 Control Panel Harnesses 821402 Crime Fighter Manual 30110 Red Buttons 30112 Blue Buttons 30118 Yellow Buttons 30119 Green Buttons 30202 Switch Holders 30250 Palnuts 30304 ‘Red Joy Stick 30305 Blue Joy Stick 30306 Green Joy Stick 30307 Yellow Joy Stick 40205 Z-Bracket 821700 Crime Fighter Bezel 821512 Outer Box For C/F Kit 821513 Control Panel Sleeve 821514 Inner Packaging 821799 Wood Control Panel a8 ae anni
Beene enn nin in noaonnnna
- *% %& IMPORTANT NOTICE x x x
The Japanese Amusement Machine Manufacturers Association (JAMMA) has introduced a new standard in video game PC.B’s. It was decided that all new products from any JAMMA member will use the same pin print-out on the edge connecter. The edge connector will have 56 pin outs, 28 per side.
Konami Inc. will offer a 56 to 36 pin adaptor P-C.B. available through your distributor. This new adaptor P.C.B. will enable the new 56 pin out to adapt to Konami’s old standard 36 pin out.
CRIME FIGHTER TECHNICAL INFORMATION
TECHNICAL INFORMATION GX821-UA SELF TEST
- Required power capacity GND-Vcc 5V 4A or more GND-(+12V) *See the Wiring Diagram.
- Output R (red) analog, positive G (green) analog, positive B (blue) analog, positive SYNC. H-V complexed, negative
- Use the volume knob on the PCB to adjust sound level. Turn the knob clockwise and it becomes louder.
- Handle with care.
CABINET INFORMATION
- Use an upright cabinet with a big control panel having four sets of an 8-way joystick and two function buttons.
- Four independent coin slots are also necessary.
- Start buttons are unnecessary. Function buttons can be substituted for them. Normal: OK will be displayed. Then the game will start. Abnormal: BAD will be displayed and the screen will stop.
MANUAL TEST
- How to start Turn on the power while the SW3 of the DIP SWITCH No. 3 is on. Push player 1 KICK button to change items.
- Test items
- ROM check . Picture contortion . Color check . YO check . Sound check . Dip switch settings *Push player 2 KICK button to change sound code. Pressing player 2 PUNCH button calls the same sound code. OaARoV
CONVERSION KIT INSTRUCTIONS
Tools Needed For Conversion:
- Heat Gun (or Hair Dryer) 2, Squeegee
- Razor Knife
- Phillips Screwdriver (Power Driver)
- Giass Cleaner
- Nut Driver
Before starting conversion, test your Main Event for any Carefully remove the four wire harnesses and the light problems. This is done by turning Switch #3 of Dip bulb harness connecting the Main Event control panel. Switch #3 on, with power off, turn on power and test.
ad a Remove the entire contro! panel by unscrewing the four With the aid of a heat gun remove the Main Event side Phillips head screws from the hinge. decals.
Spray the side ot the cabinet with glass cleaner, this will allow you to align the side decal before it adheres to the cabinet.
With help from a friend align top side decal to the back and top of the cabinet (the top of the cabinet should be completely covered) use the proper side decal, the Konami Logo should be closest to the front of the cabinet.
Using a squeegee remove all air pockets from the surface. Using a knife carefully trim excess material.
Align bottom side decal, and remove air pockets with Remove Main Event marquee and monitor bezel. Apa squeegee. Repeat steps 6 through 10 on opposite ply Crime Fighter marquee and bezel. side.
Align new Crime Fighter control panel and secure with four Phillips screws.
Connect the four wire harnesses (light bulb wire har- Remove the Main Event P.C.B. and secure the Crime ness from Main Event will not be used). Fighter P.C.B. to the same spot. Reconnect wire harness to the JAMMA connector.
Conversion is now complete, turn Switch #3 of Dip Switch #3 on and turn on power, adjust monitor and check I/O ports.
CRIME FIGHTER: SUB HARNESS FOR 3 PLAYERS & 4 PLAYERS
CN3
3P
CONTROLS
cna
4p
CONTROLS 2 [8 Jol lsjo o|a |e |r|
O/MIN[Ola|aA lowly /=
=
= i)
= o
a Coin 3
Empty 3P Left
3P Right 3P Up 3P Down
3P Punch
3P Kick
Empty Empty Empty Empty Empty Empty Ground
Coin 4
Empty 4P Left
4P Right 4P Up 4P Down
4P Punch
4P Kick
Empty Empty Empty Empty Empty Empty Ground White/Violet
White/Red
White/Yellow
White/Black
White/Blue
White/Brown
White/Orange
Black
Blue
Yellow/Black
Brown/Black
Green/Yellow
Yellow/Red
Yellow/White
Yellow/Blue
Black
yovid ova NMOUG/N3SHD SUHMWd34 SLIHM/AVED AVYD/d3y ALIHWWXOV1E ALIHW/39NVYO NMoue/an1e OVE SLIHMWANTE SLIHWdae ama AVAD/NASYD SONVYO gy qs wovia ova
(yO100 ANIV/WOTO9 aSva) wow di[ ez |e | yoni az HONNd dz JHDIY dz L431 dé NMOG dz dnd | ar] A |anaz aasn 1ON L NIOO 2 NIOO (ALd INA) (Alda) annous osaia | or | w | (Aida) a3¥ O3GIA N_ | N33YD OFGIA (Aida) Od Ast oa AS+ ano| z | ano aNd
yov1d wove AVYHD/SONVYEO MOTTSAMOVIE MOTISAIADNVYO N3389/A5NVYHO MOTIAALAIIOIN MO11aA/3N18 SLIBM/LSTOIA S.LIHM N33Y9/S.LIHM MOTISA SDNVYO aay aay yovig wovid apis Sued @PIS JeplOS ‘Ady YOTOS SHIM SSINYVH ONIYIM -YSLHDIS SIWIYD
DIP SWITCH SETTINGS
DIP SWITCH NO. 1 SETTINGS
- COIN SWITCH NO. 1 SETTINGS DIP SWITCH NO. 2 SETTINGS
1, DIFFICULTY OF THE GAME
| sw | 4 | 2 | 3 | a | cow | pay | sw | 6 | 7 | DIFFICULTY |
| o | orr | orr | ofr | orr | 14 | 1 | oFF | OFF | EASY | |||
| ON | 1 | 2 | o | on | NORMAL | ||
| ofr | ON | 1 | 3 | ore [ oN | DIFFICULT | ||
| ON | 1 | 4 | ON | VERY DIFFICULT | ||
| orr | orf | On | ore | 4 | 5 | 7 |
- SOUND IN ATTRACTIVE MODE
| ON | 1 | 6 | |||
| ore | on | | 1 | 7 | sw | | 8 | SOUND |
| ON | : | ; | OFF | OFF | |
| ofr | ore | ofr | on | 2 | 3 | Oo | ON | ON | ||
| ON | | 2 | 5 | SW1 thru SWS are not used. | ||
| OFF | ON | 3 | 1 | |||
| on | = | 2 | DIP SWITCH NO. 3 SETTINGS |
orr | ofr | on | on | 3 4
| ON | | | 4 | 4 | 1. VIDEO SCREEN FLIP |
| orF | ON | 4 | 3 | |
| ON | [ | volD | sw | 4 |
| J | O | OFF | NORMAL | |
| SW5 thru SW68 are not used. | ON | UPSIDE DOWN |
2, CHANGE OF MODE sw | 3 MODE © | orF GAME MODE ON TEST MODE SW2 and SW4 are not used. O shows recommended settings.
i + HOTU. cary a zone] oe uel
eo STOYINOD di S¥ 3KYS & WO4 7OYLNOD
<9 (NERS-ROTIED 7 |
a : l ra
ae STWYLNOD di S¥ 3K¥S we = © eras CF (oo wpnass TOT} BI ] 2 wainnoo nroo [CI fen
=} of
Pete nue | ASTR ASU nate “ a Aloe ¥3nOs O3NINDSE | f: sais wave sols s18rd
WVYSVIC ONIYIM
This page carries no recoverable text. It is a drawing or a photograph. See the original scan.
USER INFORMATION
WARNING
F.C.C. REGULATION COMPLIANCE
THIS EQUIPMENT COMPLIES WITH THE REQUIREMENTS IN PART 15 OF FCC RULES FOR A CLASS A COMPUTING DEVICE. OPERATION OF THIS EQUIPMENT IN A: RESIDEN- TIAL AREA MAY CAUSE UNACCEPTABLE INTERFERENCE TO RADIO AND TV. RECEPTION, REQUIRING THE OPERATOR TO TAKE WHATEVER STEPS ARE NECESSARY TO CORRECT THE INFERFERENCE.
“ye KONAMI ra
900 Deerfield Parkway, Buffalo Grove, Illinois 60089-4510 Telephone: (312) 215-5100, Telex: 6871385 KONAMI UW, Fax: (312) 215-5722