Sea Wolf General Instructions
Sea Wolf (set 1) (Dave Nutting Associates / Midway, 1976) · Document · 1 pages · original scan
GENERAL INSTRUCTIONS FOR "SEA WOLF”
INSTALLATION:
A. Attach and adjust 6 provided leg levelers to bottom of Cabinet. (4 to Cabinet, 2 to Step.)
B. Remove shipping cleats (located on bottom of cabinet) pull step out and secure in place with provided bolt.
C. Remove (Red) shipping bracket (located in back box area) from Periscope Assembly.
D. The power is controlled by a switch located on top of the Cabinet. Plug into A.C. only, 115 volt, 60 cycles. In low line areas (105 volts or less) a boost in the output voltage of the transformer may be achieved by removing the wire from the 115 volt tap of the transformer, and rewiring to the 105 volt position.
E. In event the game is tilted, or the line cord is removed, any eredits accumulated will reset to zero.
VOLTAGE CONTROL POT:
Located on Power Supply Board (P.C. 80-904) and is preset at
- the factory. This pot should not be tampered with unless the + the factory Servic Department is contacted.
.° TIME, COIN, HIGH SCORE AND EXTENDED PLAY ADJUSTMENT SWITHCES:
Located on Game Logic Board (P.C. 596-904) and may be adjusted as indicated on separate instructions located in back box area.
SOUND VOLUME AND TONE CONTROL POTS:
Located on Sound Generator (P.C. 596-909) and may be adjusted by rotating pots as indicated on separate instruction sheet in back box area.
HIGH SCORE RESET BUTTON:
Located on cabinet face. (upper left) High Score may be reset by depressing button-when a game is not in progress if switch #5 on Game Logic Board (P.C. 596-904) is properly conditioned.
MIDWAY MFG. CO. . 10750 W. GRAND AVE. FRANKLIN PK, IL 60131