CATHODE RAY TOMES

VS Leg Extension Kit

VS Leg Extension Kit · Kit Manual · 2 pages · original scan

Page 1

A. This kit contains the following parts.

ITEM | PART NUMBER | DESCRIPTION Q’TY

MDST-10-21 MDS-TBL Leg Extension 2

2 MDST-10-22 MDS-TBL Leg Extension Support Bracket 2

3 DJURT-80-17 Hex Head Mach. Screw M8 X 20 (Black) 18

B. Installation Procedure

  • Lay the cabinet down for easier installation.
  • To install the new parts (ITEM #1), first remove the old leg assembly, then install the new parts (ITEM #1) into the cabinet.
  • Replace the old leg into the end of the new parts (ITEM #1) as shown in the illustration attached, and install the screws provided (ITEM# 3) for each side.
Note: The table height should not be adjusted higher than 53” (from floor to top of game).
  • Install main and sub leg extention support bracket (ITEM # 2) with the 6 screws provided (ITEM# 3) for each side.
  • Make sure all the screws are tight before putting the cabinet upright.
Page 2

This page carries no recoverable text. It is a drawing or a photograph. See the original scan.