CATHODE RAY TOMES

Mystic Marathon Drawing Set (16-3008-103) May 15 1984

Mystic Marathon (Williams, 1983) · Drawing Set · 22 pages · 11 sections · original scan

Page 1
Scan of page 1

This page is a drawing, shown as the original scan.

Page 2
Scan of page 2

This page is a drawing, shown as the original scan.

Page 3
Scan of page 3

This page is a drawing, shown as the original scan.

Page 4
Scan of page 4

This page is a drawing, shown as the original scan.

Page 5
Scan of page 5

This page is a drawing, shown as the original scan.

Page 6
Scan of page 6

This page is a drawing, shown as the original scan.

Page 7
Scan of page 7

This page is a drawing, shown as the original scan.

Page 8
Scan of page 8

This page is a drawing, shown as the original scan.

Page 9
Scan of page 9

This page is a drawing, shown as the original scan.

Page 10
Scan of page 10

This page is a drawing, shown as the original scan.

Page 11
Scan of page 11

This page is a drawing, shown as the original scan.

Page 12
Scan of page 12

This page is a drawing, shown as the original scan.

Page 13
Scan of page 13

This page is a drawing, shown as the original scan.

Page 14
Scan of page 14

This page is a drawing, shown as the original scan.

Page 15
Scan of page 15

This page is a drawing, shown as the original scan.

Page 16
Scan of page 16

This page is a drawing, shown as the original scan.

Page 17
Scan of page 17

This page is a drawing, shown as the original scan.

Page 18
Scan of page 18

This page is a drawing, shown as the original scan.

Page 19
Scan of page 19

This page is a drawing, shown as the original scan.

Page 20
Scan of page 20

This page is a drawing, shown as the original scan.

Page 21
Scan of page 21

NEW POWER SUPPLY BOARD Early STARGATE games had a one-piece D-8359 Power Supply Board Assembly. In ROBOTRON and later STARGATE games, this assembly has been superseded by the new 0-8474 Power Board and outboard heat sink assembly C-8807. The new board features crowbar over-voltage protection on the +12VDC and +5VDC regulated outputs.

NEW TRANSFORMER On upright and cabaret-mode! games, a new power transformer with 8 primary and 12 secondary terminals (part no. 5610-09658) has also been substituted for the old transformer with 8 primary and 9 secondary terminals (part no. 5610-09535). The new transformer includes a 12.6V center-tapped secondary. Secondary termina! 20 and center-tap termina! 19 provide 6.3VAC general illumination power to pins 14 and 15 of plug 4P1. Cocktail table-model games continue to use a third power transformer with 6 primary and 9 secondary terminals (part no. 5610-09629).

UPRIGHT GAMES New transformer - new Power Supply: WI in, W2 & WS out.

Qld transformer - new Power Supply: W2 & W3 in, WI out and 2 Ohm 5W resistor added at R27. Pins 13, 14, & 15 of 4J1 are left disconnected when transformer secondary plug is connected.

New transformer - old Power Supply: Pins 13, 14, & 15 of 4P1 (transformer secondary connector) are unterminated at Power Supply 431 12-Pin connector.

COMPACT GAMES New transformer - new Power Supply: Wl in, W2 & W3 out.

Old transformer - new Power Supply: Wi, W2, &W3S in. Pins 13, 14, & 15 of 4J1 are left disconnected when transformer secondary plug is connected.

New transformer - old Power Supply: Pins 13, 14, & 15 of 4P1 (transformer secondary connector) are unterminated at Power Supply 4J1 12-Pin connector.

Power-Supply Notes

Page 22
Scan of page 22

This page is a drawing, shown as the original scan.