CATHODE RAY TOMES

Dambusters

Dambusters (US, set 1) (South West Research, 1981) · Manual · 10 pages · 12 sections · original scan

Page 1

cn South West Research Lid

BRISTOL ENGLAND

TECHNICAL MANUAL

DAMBUSTERS

Page 2

OPERATING INSTRUCTIONS

There are several variable options that can be obtained on ‘DAMBUSTERS’. These options can be selected by means of the test programme.

Toenter the test mode the test switch on the inside of the machine (situated behind the coindooron the left) must be operated.

To go from one test procedure to the next this test switch must be pressed once each time. The full cycle entails 7 depressions of this switch.

At the first press of the switch the machine enters the test mode which is explained below:

  • 1st press of the test switch -

CROSS HATCH

This is displayed on the screen to enable the monitor to be set up correctly for convergence.

  • 2nd press of the test switch

TALLY AND HOURS OPERATED

This display shows the amount of money the machine has taken since leaving South West Research Limited also the amount of time the machine has been switched on.

  • 3rd press of the test switch

DIP SWITCH — DESCRIPTION — STATUS

This displays on the screen the current selection of the tiny ‘Dual-in-line’ switches located on the electronics board. Access to these can be gained via the back door.

The operation of these switches is explained as follows:

DIP SWITCH 1 — 2nd COUNTER

This capability exists to charge the 50p coin mechanism to accept 10p coins, and vice-versa, by operating switch number 1 on the ‘dual-in-line’ switches.

The 50p coin mechanism corresponds to the 2nd counter situated on the side wall near to the test switch. The 2nd counter is the one below the 1st counter.

DIP SWITCH 2— GAME COST

The game cost may be changed from 10p to 20p per game by operating switch number 2 on the ‘dual-in-line’ switches.

The ON column as shown on the screen is for 20p and the OFF column is for 10p. Operating switch number 2 will read on the right-hand side of the screen either ON or OFF.

Page 3
  • DIP SWITCHES — DESCRIPTION — STATUS (continued)

DIP SWITCHES 3 & 4 — HITS ALLOWED

The number of lives lost perhit i.e. damage to aircraft, can be changed to vary game difficulty by operating switches numbered 3 & 4 on the ‘dual-in-line’ switches.

When operated these switches change the status on the far right of the screen to read ON or OFF.

Decide the number of lives the player is allowed to lose per game from the list of 3, 4, 5, 6. Operate switches 3 & 4 toread downwards to correspond with the number chosen reading from left to right. An example of this would be both switches in the ON position foragameallowing6 lives to be lost, then the game wil! end.

DIP SWITCH 5— SPARE 1

This switch is a game test switch and MUST be left in the OFF position.

DIP SWITCH 6 - SPARE 2

The Union Jack in the Attract mode can be removed by operating switch number 6 on the ‘dualin-line’ switches. This facility can be used when the machine is situated in sensitive areas or countries.

The Union Jack will be displayed when the switch is in the OFF position. To remove the Union Jack the switch will need to be in the ON position.

  • 4th press of the test switch

MAXIMUM GAME SELECTION

This facility can be used to select the maximum amount of time allowed per game. Decide the number of minutes to be allowed from the Game Time List of 9 mins, 4.5 min, 2 mins, and 1.8 mins.

By moving the joystick upwards or downwards make the red brackets enclose the corresponding number in the option list of 1 to 5. Press the Bomb button to set and to print out the Current Selection.

  • 5th press of the test switch

TEST — SCREEN ALIGNMENT

When the test switch is pressed for the fifth time the machine enters into a Confidence Test of Electronics and will stop and display any faulty areas, if not it will continue up to the SCREEN ALIGNMENT display.

  • 6th press of the test switch

COLOUR BARS

This display shows colour bars for monitor alignment.

  • SWITCH TEST ROUTINE

This display allows you to test the fire buttons, the coin mechanisms, and the Joystick movements and Bomb button. When these are operated one at atimea

Page 4
  • SWITCH TEST ROUTINE (continued)

red oblong will show against each description to indicate that they are functioning correctly.

To test the coin mechanism an appropriate coin must be dropped through-when the door is open; the coin being collected in the hand. When the coin is going through the mechanism the ted oblong will flash on the screen. Try this test a few times to double-check. The coin mechanism test can be done without incrementing coin counters or giving any credits.

To exit from the test programme press player one and player two buttons simultaneously.

In conjunction with the test programme and video display monitor can be set up. Brightness or brilliance, however, is best set up in the Attract mode. This is best adjusted when the pages are changing and the characters cannot be seen as a grey shadow before the vertical sweep of colour fills the screen.

All other adjustments are done in the test mode by cycling to the required test using the test switch.

SOUND VOLUME

The volume of all sounds will be altered by a small potentiometer situated next to the ‘dual-in-line’ switches on the electronics board.

SWEAR WORDS

The games board programme will automatically reject most swear-words on the high score ‘Roll of Honour’ display. However, if you find offensive words on the ‘Roll of Honour thereis akey switch at the back of the machine near the bottom on the right which, when operated, will remove all the names and offensive words. it will, however, keep the actual high scores on the screen. If the key switch is inadvertently left in the ON position each page of the attract mode will quickly flash around. The operation of this key switch during a ‘game play’ will not interrupt the player, but it will clear the offensive words.

N.B. This switch is the only switch which is not tested in the test mode.

INITIALISATION

This is done prior to the board or complete machine leaving the factory. It puts the coin counters, total taken and hours the machine is on back to zero, (test 2).

If the machine requires Initialisation at any time in the future please contact South West Research Limited. :

Page 5

DAMBUSTERS EDGE CONNECTOR PIN-OUT

ALL SWITCH TO 0 VOLTS

THE COUNTERS RETURN TO + 12 VOLTS

0 Volts 0 Volts

OVolts OVolts

+5v+ -2% +5iv+ -2% +5iv+ —2% +5v+ -2%

NIC NIC

NIC NIG

50p/10p Count 10p only counter

50p/10p Credit 10p only credit

Test Switch Bomb

Fire Rear Fire Forward

2 Plyr (pilot) St 1 Plyr (pilot) St

NIC Down Descend

Right (Increase throttle) Left (Throttle back)

Swear Word Key Switch Up Climb

NIC (Ov SCN) Ov SCRN

Red Blue

Synch Green NIC Sound

+12v +12v +12v +12v O Volts 0 Volts

0 Volts 0 Volts

N.B. All 0 volts connection must be wired together All + 5v connection must be wired together due to currents drawn.

Page 6

SK1 EDGE_CONNECTOR LIGHT FITTING

SK2 24 WAY CONNECTOR

oe, +2 Z 3_[5y 4 [UP

RIGHT. g {~8_[ DOWN,

41] ONE PLAYER 42_] TWO PLAYER

kid ae Eble 119 [BOMB TEST SWITl

SOp_ CREDIT {21_| 1p CREDIT 123 | R [S0p COUNTER | 24 1 10p COUNTE!

owiTOR RT RED, G TGR

NOTE-ALL NODES CONNECT ON EDGE

CONNECTOR EXCEPT NODES

MARKED M SWEAR SWITCH GREEN B [BLUE SY NCH, Ov SCREEN 6Ov_AC 240v AC

POWER _ MAINS SUPPLY

S SIMPSON CHECKED | (2. Ay Tien | ENGINEER [ (Pose |

SOUTH WEST RESEARCH LTD

2-12 MILL LANE, BEDMINSTER, BRISTOL, ENGLAND.

TITLE DAMBUSTERS MAIN LOOM APPROVED | YW SCALE 10 DECEMBER 81 DRAWING No| SWR O103 {SHEET 10F 3)

Page 7

TEST

Vis

SOp COUNTER 23 =

NOTE-ALL NODES CONNECT ON EDGE CONNECTORS SWITCH

SK3 6 WAY CONNECTOR

Te TREN IT

  • T It &['50p COUNTER OUT ST *5v 6 We 7 [+i2y
  • up.

7 DOWN { —~— LEFT RIGHT

_ i 80MB {— FIRE. FORWARD _ FIRE BACKWARD

—_ ‘J ONE PLAYER {| ‘—J TWO PLAYER 4}

aaa SOUTH WEST RESEARCH LTD pea fe 2-12 MILL LANE, BEDMINSTER, BRISTOL ENGLAND. YILE TITLE | DAMBUSTERS SECONDARY LOOM DRAWING No| swe 0103 (SHEET 2 0F 3) 14 DECEMBER 81

Page 8

COIN DOOR LAMPS

0p CREDIT IN Op COUNTER 0 SOp CREDIT_IN [S0p COUNTER OUT [4 | 6 | + +i ee Op [+5v TS [Ov [+i2y

4Op COIN COUNTER

50p COIN COUNTER

SCALE

SOUTH WEST RESEARCH LTD

2-42 MILL LANE, BEDMINSTER, BRISTOL ,ENGLAND.

DAMBUSTERS COIN DOOR LOOM

DRAWING No} SWR 0103 [SHEET 3 OF 3) 14 DECEMBER 81

Page 9

SOCKET

N DATA BUS NZ FROM ree ue aL | aE PROMS Log 8 3 EEE ons PRG “6E- 11 a SKS

Re Cikz—}

9491 BAND GAP DRAWN [5 SMPSON CHECKED \kpewe ee | ENGINEER APPROVED [fe {_——— SESE Gi DRAWING No] SWR 0100

SOUTH WEST RESEARCH LTD

2-12 MILL LANE, BEDMINSTER, BRISTOL, ENGLAND. TITLE | DAMBUSTERS DAUGHTER BOARD

Page 10

[oaTE [SCALE [BRAWN —_[S SIMPSON

TLE 19 JANUARY 1982 _]ORAWING RG] SWR_O1OL (VIDEO GAME BOARDS ‘SOUTH WEST RESEARCH LTD