Amidar
Amidar (Konami, 1982) · Document · 13 pages · 13 sections · original scan
AMIDAR
WARNING: THIS EQUIPMENT GENERATES, USES, AND
CAN RADIATE RADIO FREQUENCY ENERGY AND IF NOT
INSTALLED AND USED IN ACCORDANCE WITH THE
INSTRUCTION MANUAL, MAY CAUSE INTERFERENCE
TO RADIO COMMUNICATIONS. AS TEMPORARILY PERMITTED BY REGULATION IT HAS NOT BEEN TESTED FOR COMPLIANCE WITH THE LIMITS FOR CLASS A COMPUTING DEVICES PURSUANT TO SUBPART J OF PART 15 OF FCC RULES, WHICH ARE DESIGNED TO PROVIDE REASONABLE PROTECTION AGAINST SUCH INTERFERENCE. OPERATION OF THIS EQUIPMENT IN A RESIDENTIAL AREA IS LIKELY TO CAUSE INTERFERENCE IN WHICH CASE THE USER AT HIS OWN EXPENSE WILL
BE REQUIRED TO TAKE WHATEVER MEASURES MAY BE
REQUIRED TO CORRECT THE INTERFERENCE.
Stern Electronics, Inc. 1725 Diversey Parkway, Chicago, Illinois 60614, 312/935-4600, Telex 25-4657
12A-290
The object of the game is to avoid the Amidars "attackers", and pick up the coconuts to capture territory, When the Amidars close in, push the jump button to make the Amidars jump, at this time you can pass under them to escape (only four jumps per frame).
Each coconut is worth 10 pts. when picked up, when the four corners are filled in the Amidars change colors and can be thrown off the trail. The first Amidar is worth 200 pts. the others multiply by 2 up to 1600 pts.
When the complete screen is filled in you have the opportunity of collecting 5000 bonus pts. When the paths show up push the jump button to start the pig down the paths. The pig will move randomly towards the bottom to pick up the fruit.
On the next frame, roll the paint roller around each square to capture territory, and collect points that are in the square. You can only paint the adjoining squares.
1.1
1.2
1.3 SECTION 1 INSTALLATION
INTRODUCTION
This game has been STERN final tested and is ready to play, but on all games there are some items that must be checked after shipment. Making these visual inspections may avoid time consuming service work later. Minor troubles caused by abusive handling in shipment are unavoidable, such as cable connectors that may have become loosened. Check ALL CONNECTORS on the game to make sure they are firmly seated. Check to make sure that the game control boards are firmly seated. Examine the exterior of the game cabinet for dents, chips or broken parts, Check all major sub-assemblies, contro! panels, and T.V. monitor to make sure that they have not loosened up during shipment.
VISUAL INSPECTION BEFORE PLUGGING IN LINE CORD
- Check the transformer for any foreign material shorting across wiring lugs.
- Check that fuses are firmly seated and making good contact. Line fuse (3 AMP SLO-BLO) located on the transformer board, fluorescent lite fuse (1 AMP SLO-BLO) located on the fluorescent board, and 3 circuit board fuses - located on the power supply board (See drawing B).
- Check the T.V. for any foreign material that could cause shorts (VISUAL INSPECTION ONLY).
- Check game boards for any foreign material that could cause shorts. Make sure ribbon cables are pushed into circuit boards.
ON/OFF POWER INTERLOCK SWITCHES
-1, The on/off power switch is located on the top right side, 12
- inches from the front.
- There are two interlock main power switches by the front door and one by the back access panel.
- Interlock switch interrupts all power from game except service outlet. Interlock switch can be locked in “on” position by pulling stem out when servicing game.
1.4 GENERAL INFORMATION
1.
2. On front door there is a service switch. Depressing this switch will coin machine without advancing coin counter (if installed). Wiring for a counter is inside the front door on the left hand side of cabinet. (6 VDC COUNTER).
There are two coin chutes on the front door that are connected in parallel.
Game adjustment switches are located on CPU board. (See below for adjustments).
The electronics package used in AMIDAR is the same for . stand-up model and cocktail table model. (They can be interchanged if Dip Switch #3 is changed on CPU board).
Volume control for electronic sound is located on CPU board.
Power supply board has an adjustment (See DWG B) for the +5 VDC regulator, this MUST BE SET BETWEEN +5.0 VDC and 5.25 VDC.
The crosshatch, seen during power-up, is used for convergence on the monitor. To get a constant crosshatch hold the player one start button during power up.
GAME ADJUSTMENTS
SWITCH 1 2 GORILLA’S OFF OFF Freeplay
| OFF | ON | 5 |
| ON | OFF | 4 |
| ON | ON | 3 |
SWITCH —_3__ OFF Table ON Up Right
Cont'd, on next page.
GAME ADJUSTMENTS CONTINUED
SWITCH 2-H
4 5 6 COINS PLAYS
OFF OFF OFF 1 1
SWITCH 7-K
4 5 6 COINS PLAYS
| ON ON OFF | 2 | 1 |
| ON OFF ON | 3 | 2 |
| ON ON ON | 1 | 4 |
OFF ON ON FREEPLAY
| -1 THRU 8 ON | 1 | 1 |
. #5V TRANSISTOR MOUNTED ON ‘BACK OF BOARD
TRANSFORMER
ROCKETS
CABINET MODEL
COIN SWITCH
COIN SWITCH a (2 (3 (4 (5 (6 {000000
{00000000 RIBBON CABLE
HEAT SINK+ mm 7 LOUD-TURN i 2-H CLOCKWISE —“f
VOLUME CONTROL
PROGRAM £-PROMS
AMIDAR
12A-253-145
44-173 BA-111-1 BA-111-2 12D-339-S 12G-10-172-M 12G-10-172-S 124-281 34C-978-S 13C-2-32 Packing List: Plastic Bag 1 AMP Fuse 2 AMP Fuse Monitor Schematic Manual Schematic Return Card PS-1200 Schematic Quarter Window
NO G3LNNOW HOLSISNVUL AS*+ i E
If during power up & game play screen color goes to red, adjust pot R2 to a voltage setting between 4.75 volts & 4.85 volts. Voltage to be measured between pin B18 (+5VDC) & pin B17 (GND.) on top logic board.
REVISIONS
a | issue er. oose2. leodgand. 2N6226
Los cr KBPC6005 BRIDGE
+ SV. REG. 4 15,000 wr 4 ew
as +5v Res
fi CRB Fe ~ +> sss | 2a Se ors Bio.
a aoe: 4 3
eBaelY NS t tev unes aol RESO _—
FoR 240 Le, Connect 2.703, 5 tanp't sHocto coMotLne
NOTES:
[> SHOULDER WasiieR REQUIRED ON MOUNTING STUD [E> cenemar instataents 6.3. VRMS 70 GEN, TLL.
u cre FS R6 2 }¢—4-S)"|_ 9-9 Vv IN naoos 1A SH | 752M 2 " res ono | vey 6 D 7905 \odeuro i 103 VRMS 35 i “TH To MONITOR
POWER TRANSFORMER = 160-26-1
sTE |" ELECTRONICS, INC,
SCHEMATIC ,POWER SUPPLY
PC. BOARD
34C -978-S
@—com counters @-smnc @-awe @—xe0 Green @-reser @—cow counters @veB @-m @—o87 @-na6 @—oas @-304 @-0a3 @ 082 @-081 @-080 @a4es Q-see Oma OT RRSERET Z 08106 bran 3 yr 33
1586
‘Blue
GREEN
RED
Ir 0 exo PR Green
6331-1 ie
rps
{24 cd isia6 lr >t ho 470. oP atue ese2— a
6E Fa 5040202 D0
saa 18/57 OB
NOTES - + te o5¥
4 56ND" ov wa ie
AMIDAR
+5¥
GND
BLUE GREEN RED SYNE
SPEAKER (BE)
2801815 UN rer: Efe ae @ 25036! fe
1% 220 E coIni = Caio Tour cone Co F pac a your ‘Pa 220, 34] IP LEFT Bg_)-PS eas The) go FOuF IP RIGHT Cag aap Spt 1P SHOOT CATS aur SERVICE BTS wouse Cag ae 2P uP fae AS FOF 8285) 430 nes PRT IE D6 —E) s—®) oum—S 03—®) 2B2—) cy
100uF
Kral BHAT
| 4P START | — | taF | ||
| 2P START | iP | 220 | SOME | ellos |
| i | z | FOF 23) | RESE |
2puerr Cad) tes
| 20 RIGHT CBa | tS | —S | tera |
| 2p sHoor Cad | )-ps | ella | |
| wo use CBZ | pape | : | ese |
FoF il 3 21
pcs C2 ch PCO
toca
PCE a
| Wo USE | es | - | locs |
220 GND ‘MO USE RESID eS m—S AB5s—@) ABO ro PID
ovr. v6: Vs. ov. Dy3. bve- OVE ov0-
cur is]
cox xB.
- NOTES —
@: HILAR CARMCITOR. ©): ELECTROLYTIC CONDENSER. WO MARK; CERAMIC CONDENSER. @; TANTALUM ELECTROLYTIC CONDENSER,
CBE ; 36 Pm connector, 8 is parts side, @ =; 4 iw connecror, CD : 2 AW connector. +t 3 wee, +sy 13 GMD. ov
N Berean Sees, theories
AMIDAR
The enclosed program is an updated version for your Amidar game. This program speeds up game play with increased difficulty to decrease play time on the game. The new chips go in the board locations indicated on the chips. The dip switch settings change with the new program, the changes are detailed below. Also notice that the bonus routine is adjustable between 30,000 and 50,000 points.
DIP SWITCH LOCATION 8P
SWITCH COIN, PLAY
1 2 3 4 OFF OFF OFF OFF OFF OFF OFF ON OFF OFF ON OFF OFF OFF ON ON
OFF ON OFF OFF OFF ON OFF ON OFF ON ON OFF OFF ON ON ON Rowe KNOW FWrn—
ON OFF OFF OFF ON OFF OFF ON ON OFF ON OFF ON OFF ON ON
ON ON OFF ON ON ON ON OFF ON ON ON ON wer Noun
ON ON OFF OFF 3
F REEPLAY
DIP SWITCH LOCATION 6P
SWITCH PLAYER 1 2 NUMBER OFF OFF >; OFF ON 4 ON OFF 5 ON ON 256
ore TABLE ON UP-RIGHT
4 BONUS OFF 50,000 ON 30,000
5 ATTRACT MODE SOUND OFF Off. ON ON
THESE(.CHIPS ARE CHARGED AGAINST YOUR ACCOUNT ,PLEASE RETURN THE OLD CHIPS TO YOUR DISTRIBUTOR AS SOON AS POSSIBLE. P.S