VS Excitebike
Vs. Excitebike (set EB4-3 E) (Nintendo, 1984) · Document · 3 pages · 4 sections · original scan
VS.EXCITEBIKE
(Operation Manual)
|. How to install Software ROMs
Each Software ROM is labeled with a Location Number shown on it ({XQ Shaded Portion illustrated below), which indicates the corresponding location on the P.C.
Board where it should be installed.
(Label on Software ROM)
“VS.EXCITEBIKE” contains 6 Software ROMs, and 1 Custom IC, which have location numbers, 1A or 6A, 1B or 6B, 1C or 6C, 1D or 60, 2A or 8A, 2B or 8B and 2F or 8F. Each ROM and IC must be mounted into the proper IC Socket.
For VS.DUAL SYSTEM (two monitors): If “EXCITEBIKE” is to be installed in main (left) side of cabinet, then EPROMs and Custom IC should use locations 1A, 1B, 1C, 1D, 2A, 2B and 2F. For sub (right) side, use locations 6A, 6B, 6C, 6D, 8A, 8B and 8F.
For VS.UNISYSTEM (one monitor): “EXCITEBIKE” EPROMs and Custom IC must use locations 6A, 6B, 6C, 6D, 8A, 8B and 8F (sub side).
@©@ ABC DEFH J K LMN PR
SW1 corresponds to this program. MAIN (Left side for two monitor game--Not used for one monitor game) s fs] a g fe) c
SW2 corresponds to tnis program.
SUB (Right side for two monitor game--Also used for one monitor game) ©)
ROM and IC Location on P.C. Board
This page reads as a drawing: its text was drawn rather than typeset, and comes out in fragments. See the original scan.
CAUTION
The suggested factory settings for VS. Excitebikel™ are listed below. It is recommended that vou carefully check the dip switch settings prior to operation. For the VS. DualSystem=", the dip switch settings will pe on either SW1l or SW2, depending on which side of the p.c. poard you install the EPROM's and custom IC. Refer to the operation manual for further instructions. For the VS. UniSystem™M, the EPROM's and the custom IC must be installed in the "sub" side of the p.c. board, and then SW2 is used.
MES-01-Co ac
P ; 7 \
| SW1L or SW2 | | | } | \\ |
N
M =
ie wi 26 3 mB »
| ° | @ | = | ¢ |
| e | & | mH Be | |
| < | £ | mye |
[} ‘ ‘ a)
Please refer to the dip switch settings label and the VS.-PAK™™ Operation Manual for further information.
intendo of America Inc.