CATHODE RAY TOMES

Kid Niki Radical Ninja Conversion Kit Addendum

Kid Niki - The Radical Ninja (Data East) · Addendum · 3 pages · original scan

Page 1

KID NIKI - THE RADICAL NINJA

ADDENDUM TO INSTALLATION & SERVICE MANUAL

Data East has included a different Main Harness and EMI Filter PCB in this conversion kit. The following information indicates the changes you need to be aware of when installing this kit.

The different components are:

  • EMI Filter PCB, IREM style 520-0014-00
  • Main Harness, IREM, Kit 016-0147-00
Note these changes on Page 3 of the Installation & Service Manual.

The Main Harness edge connector pin-out now matches the Logic PCB edge connector. Replace the pin-out diagram on Page 11 with the diagram shown on page 3 of this addendum. Disregard the Main Harness edge connector diagram on Page 12.

NOTE: To prevent excessive radio frequency interference, the EMI Filter PCB must be utilized.

Replace the Specific Wiring Information on Page 13 of the Installation & Service Manual with the diagrams on Page 2 of this addendum.

The above reflects the changes required to the Installation & Service Manual. Please keep this addendum with the manual for future reference when servicing this game.

Page 1 of 3

Page 2

1P DOWN

1P uP

(P LEFT

1P RIGHT

IP START

2P START

IP sHosT 1 Gworp)

IP sHooT2 Gump)

GROUND

> CONTROL, PANEX e

+l12v Gsv) >

12 (5) vot inaoo8 IN COUNTER, IN4co2 COIN CoMTER |

ON GUNTER 2

a¢s) wr COIN COUNTER

BOM, SWATT SPEAKER

'COIN MECH DOOR thet

(> = fri FiLTer PCB EDGE CONNECTOR, HARNESS

Page 2 of 3

Page 3

EDGE CONNECTOR PIN-OUT

FOR LOGIC PCB AND EMI FILTER PCB

MAIN HARNESS EDGE CONNECTOR PIN NUMBERS IN ( )

OMP SIDE SOLDER SIDE FUNCTION HRNS PCB PCB HRNS FUNCTION

GROUND(22) 12{Z)GROUND
GROUND21 34yGROUND

COIN COUNTER A 1P CONTROL LEFT 2P CONTROL LEFT. << [

12 (U 2P_CONTROL RIGHT

1P CONTROL PUSH14 (T)2P CONTROL PUSH 1
1 PLAYER START15) 15 | 16 (Ss2 PLAYER START
  • 17 | 18 (R) COIN COUNTER B
COIN SWITCH B13) 19 | 20 (PVIDEO SYNC

+ 12 VOLTS (12) 21 | 22 (ny [+ 12 vonrs

+ 12 VOLT[(11) 23 [24 (mM)[+ 12 vours

[SPEAKER (-) | (10) 25 [ 26 (u) | SPEAKER (+) | |_aP CONTROL PUSH 2| (9) 27 | 28 (kK) | 2P CONTROL PUSH 2 |

VIDEO BLUE 32H

2P_ CONTROL UP(6) 33 [ 34 (F2P CONTROL DOWN
1P CONTROL UP.(5) 35 | 361P CONTROL DOWN
SERVICE SWITCH4) 37COIN SWITCH A

+ 5 VOLTS

  • 41 | 42 (Bp) | + 5 vouTs
  • 43 [44 (a GROUND
CAUTION! The PCB edge connector is numbered from right to left as shown below, however the Main Harness edge connector is numbered from left to right. The pin numbers in parenthesis ( ) in the diagram above refer to the Main Harness edge connector.

Page 3 of 3