CATHODE RAY TOMES

Xenophone Bulletin Dual Power Amp Board Modification (Aug-19-87)

Xenophone · Service Bulletin · 2 pages · original scan

Page 1

DUAL POWER AMP P.C. BOARD MODIFICATION

the master cable in this game was designed for use with the DUAL POWER AMP P.C. Board #A084-90910-F000. When it is determined that the DUAL POWER AMP W/MIXER P.C. Board #A084-91648- A000 is to be used in the game, the following modifications procedure must be used to adapt the master cable to the board.

HOW TO ADAPT MASTER CABLE

STEP 1 - Turn off power to the game and open the rear access door.

STEP 2 - Locate and remove the DUAL POWER AMP P.C. Board from the right side wall (looking from the rear of the game.

STEP 3 - Install the DUAL POWER AMP W/MIXER P.C. Board in the same (relative) location where the DUAL POWER AMP P.C. Board was removed from.

STEP 4 - Locate the Amp To Amp W/Mixer Conversion Cable #AE85-00027-0000 in the game Spare Parts Kit.

STEP 5 - Connect the 8 position header from the Conversion Cable to the 8 position connector on the master cable. Next, connect the 11 position connector on the Conversion Cable to the DUAL POWER AMP W/MIXER P.C. Board connector #Jl.

STEP 6 - Close rear access door and return game to Play Mode.

PARTS & OPERATING MANUAL #0E85-00300-0000. MODIFICATION

The piloterun manual's Cabinet Wiring Diagram #M051-O0E85- A003, page 3-28, illustrates the DUAL POWER AMP W/MIXER P.C. Board installed in the game. Page 3-29 illustrates the DUAL POWER AMP installed in the game.

The production run of the manual!s will] illustrate both P.c. Boards, on page 3-28.The part number for the Wiring Diagram #M051-00E85-A003 will remain the same. The ‘pilot run' Wiring Diagram was 3 pages in length. The 'production run' will be 2 pages in length.

ca

f.a1. Ab ehelen FORM NO. Mn51-00FA5~AN2-

Page 2

PLEASE NOTE:

The Master Cable Harness for this game was designed for use with the standard Dual Power Amp P.C.Board

(A084-90910-XXXX).

To operate the game using a Dual

  • Power Amp w/Mixer (A084-91648-XXXX)

attach the adaptor cable provided in the spare parts kit

the spare parts kit.