CATHODE RAY TOMES

Plinker's Canyon Bulletin

Plinker's Canyon (Sega, 1977) · Service Bulletin · 2 pages · original scan

Page 1

INFORMATION BULLETIN

PLINKER'S CANYON i’ Se reer a se as SEGA Regarding: Conversion of coin lockout PCB Assy. SS) coe p \ To prevent operation of coin lockout delay circuit the

procedure listed below must be taken. The modification which

includes the replacement of the present MPU, 260011 PCB with

a new MPU-2K-P1A 260034 PCB will provide individual starting

time, extended game time, gun stations and independent timed

game.

  • Remove A.C. power before proceeding with conversion.

Remove the coin lockout PCB assembly 260031 from the

gun cabinet and add a jumper wire from IC4 pin 9 to IC4

pin 7 using a pencil soldering iron of not more than 25

watts to prevent damage to the I.C. Refer to sketch.

{él 2 al

tS Q

ap Tos Coin Lockout PCB

Or a Assembly

omy ENT vb

  • Re-install modified coin lockout delay PC Board.
  • Remove MPU, 260011 PC Board from the XA1 position on the

back plane.

Page 2

PLINKER'S CANYON (PAGE 2)

Refer to the dip switch function sheet for proper

switch settings of the new MPU-2K-P1A, 260034 PC

Board Assembly.

Install new MPU-2K-P1A, 260034 PCB in XA1 position of

the back plane.

Apply A.C. power and test machine operation.